Question about 2005 Pontiac Vibe

Open Question

Removal and replacement of interior sun visor 2005 vibe

Is this fairly strait forward...just remove the screws and pop out..and pop the new one in and tighten down screws..it appears on the new visor that the screws hold the visor and expand the clips...was just wondering if there were any little tricks or information to preform the task..it came from the dealer with no instructions..if it looks like it should work and it don't...i tend to force things..don't want a mess up the wifes car..ya know..thanks

Posted by on

5 Suggested Answers

LAYNRAIL
  • 18 Answers

SOURCE: Dash removal for installing a radio

you just have to pull on it a bit, there is clips behind it. they are a little tricky so be careful, but ou have to use a bit of force

Posted on Jan 09, 2009

polarcycle
  • 1392 Answers

SOURCE: how to remove interrior door panel pontiac G6 and replace broken

Remove any bolts/screws you can see then get a plastic crowbar and pry it off. Should have little plastic push pins holding it to door. Make sure you remove all screws though.

Posted on Mar 06, 2009

  • 202 Answers

SOURCE: Sun visors won't stay flipped up.

most of the times on the visors if you look at were it mounts on the car you will see a small screw this is a set screw and if you tighten it just a little bit it should hold your visor up for you. but not all vehicles have a set screw as iam talking about. and if the impala dosent you need to get a compleat new visor
hope this helps you out

Posted on Apr 30, 2009

  • 1 Answer

SOURCE: sun visor won't go back into place

if its flopping around or feels loose you can try tightening the "hinge" that connects it to the roof and tightening the screws on the visor itself. That might align it enough to fit again properly.

Posted on May 26, 2009

pixeldawg
  • 71 Answers

SOURCE: sun visor replacement

You unscrew the two bolts and gently take the visor off the mount. There will be a wire attached that has a plastic male/female connection that can be pulled apart. Do this gently. The wire is the power connection for the vanity light located within the visor.

Posted on Jun 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove drivers side visor from 2003 sonata gls w/sunroof


Most commonly you'll have two screws where the visor attaches to the roof. Remove the cap / cover with your finger nail or a butter knife with a thin towel (like a t-shirt) starting on the edge towards you, don't overly force it. The cap will pop off one clip at a time (small snap sounds). Get the first snap and then work around the cap to pop the others out. The cap will pull back towards you and you'll see the two screws. Remove the screws and the visor will come out (pull it down with light force if needed).

Mar 09, 2015 | Hyundai Motor 2003 Sonata

2 Answers

How do I get the sunvisors off so that I can put new material on the roof of my `996 Jeep Grand Cherokee Laredo?


Remove the two screws located on the fulcrum bracket of the visor (they may be concealed by push caps), unclip it from it's catch, and pull the bracket down gently. Depending on the visor there may be wires still attached. Continue pulling the wire out of the hole until you see the connector and then disconnect it.

Sep 02, 2011 | 1996 Jeep Grand Cherokee

1 Answer

Installing a sun visor, right side. 2007 Hyundai, bought new. Right side visor wouldn't stay up, replace by dealer under warranty. Left side visor did same thing at 67000 miles, not covered. New...


There is usually a cosmetic cover hiding the two phillips head screws which attach the visor to the overhead. These covers 'clip' in place and can be removed using a small flat tip screwdriver. Once removed, you can then access these two phillips head screws. Remove the screws & gently remove the visor. You will find a wire harness connector to the visor. Find the release tab on the connector & press on it to disconnect the visor from the wire harness in the overhead. Installation is reverse of removel.
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.

Sep 02, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

Drivers side sun visor, 2006 Toyota rav 4 will not stay up


there isnt really a quick fix for this, i suggest you buy another sun viser from the dealers and fit it in.

its realy easy to fit, it normaly just has a cosmetic cover that goes over the screw, pop this cover off, remove the screw and refit the new sun visor.

Feb 15, 2011 | 2006 Toyota RAV4

1 Answer

The sun visor on the drivers side droops down. Other than replacing it, how can I repair it so it says up?


Screw a small self taping screw just inside the hinge pivot. this can help tighten the visor to the pivot.

Jan 04, 2011 | 2003 Toyota Highlander

2 Answers

How do I remove the 2007 kia optima sun visor?


Look at the plastic plate that the visor arm comes out of. There are screws underneath the plate. You need to adjust these screws, and that should take care of the problem.

Sep 25, 2010 | 2007 Kia Optima

1 Answer

Need to repair/replace broken sun visor vanity mirror hinges on 2005 Corvette.


i would go to your nearest dealer and order the sun visor you will need a 15 torx bit three bolts remove and replace you should be able to handle this repair yourself and save about 100 bucks good luck

Nov 27, 2009 | 2005 Chevrolet Corvette

1 Answer

Driver side sun visor falls down


If you have anything on top of the visor, remove it. If there are any screws visible near the pivot rod, tighten them. You can remove the visor and slightly bend the pivot rod, inside the visor. You can just buy a new one and replace it yourself. It's only a few screws.

Sep 16, 2009 | 2005 Nissan Murano

1 Answer

I have a suzuki samurai and the sunvisors won't stay up


See if there is a screw present in the area where the visor and bracket meet. If so, tighten the screw. This places a drag between the two so the visor remains up or down

Jul 30, 2009 | 2004 Toyota Highlander

Not finding what you are looking for?
2005 Pontiac Vibe Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...