An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
An expert that has over 500 points.
Re: 2002 F250 Cruise Control and Washer Fluid pump don't...
I looked at the owner's manual (starting at pg 162) at the fuse block and it does not mention either of those two particular functions as they relate to a specific fuse. I would recommend you get a tester and check all the fuses to be sure. Good luck! Oh yeah, you can get a copy of the owners manual in PDF format by going to MotorCraftService.com
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
jnjkingbird, It sounds like this problem is the clock spring as I don't believe that the horn and the cruise control would share a fuse. However, they do share a circuit in the clock-spring. You can check for power at each unit (horn and the cruise control) which would confirm this. Check each fuse as well. Good luck with this.
There are 3 places on the Rav4 where fuses can be located and checked. for the cuise control.
The back of the cruise control stacking switch has been know to fail (fall apart) and Toyota issued a TSB with replacement switch.
if it is the fuses then they most likely are related to cruise control system: Stop, Dome, Gauge and Igniton
The interior fuse box
The main engine fuse box (by brake fluid)
Cruise control ECU is under the glovebox.
Cruise control actuator is under hood (by driver side brake fluid/booster)Throttle position sensor (to detect if your foot is on gas pedal)
Cruise control switch on the clutch pedal too (if you have 5spd manual)
Brake lights are the deactivate signal for the cruise control
If a gas engine, check the switch on top of the brake master cylinder (cruise control deactivation switch) if it is leaking brake fluid it will cause too high of resistance causing the cruise system to think the brakes are being applied. Recall 05S28 applies to this problem. Juming the connector will confirm this.
A couple of things you can check,make sure you have brake lights,check the following fuses in the fuse panel under dash:
If this is a gas engine check fuses 27(15amp) and 34(10amp),if this is a diesel check fuses 22(20amp),34(10amp),and 45(10amp).
Any further diagnosis you would need a scan tool.
try the fuse first. then try sticking a pin into the washer jets. then try having the washer fluid pump/motor replace. if those are not the case, then you need a new switch to operate the pump motor. (a whole new control column)