Question about 2001 Chevrolet Camaro
There's an access in the bottom of the air deflector under the bumper. 2 screws in the bottom of the light and one in the back. Unplug the sockets and pull the lens out of the bumper.
Posted on Dec 23, 2008
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jan 15, 2014 | 2002 Chevrolet TrailBlazer
Feb 18, 2011 | 1993 Oldsmobile Cutlass Supreme
Feb 02, 2011 | 2004 Pontiac Grand Am
Jan 16, 2011 | Ford Ranger Cars & Trucks
Changing front, right turn signal on 2005 Buick Terraza:
Open hood; when facing the front of vehicle, the right turn signal is on the passenger
side (left). The headlight assembly
needs to be removed to easily reach the turn signal. On my vehicle, there is a 10 mm screw on the
left side. Remove it. There is L-shaped pin on the right side of
the headlight assembly. Swing the pin counter-clockwise
(to the left). Pull the pin straight up
to remove. The headlight assembly is now
loose, but there is a pin snapped in a socket on the back of the assembly that
still holds the assembly. Pull the
headlight assembly hard and straight to the front of the vehicle. When it snaps loose, the assembly is now held
just by the rubber gasket surrounding the assembly. You need to gently work the right side of the
gasket out of the grill cowling. The
assembly should pull straight out. The
wires are long enough to lay the headlight assembly in the engine compartment. Finally, the turn signal is now accessible. Twist the light holder counter-clockwise and
pull out the light holder. Change the
bulb. Do not punch your man-card for
credit until you have successfully reinstalled the headlight assembly. It goes back in a little easier the second
time. Once you have put the L-pin in
place, the screw back, and successfully tested the lights, you can now punch
I give the mechanical engineers and designers a D-minus instead of an F only because I was successful on the first try. No light bulb on anything commonly used by people should be this hard to figure out.
Sep 07, 2010 | 2005 Buick Terraza
Mar 07, 2010 | 2000 Chevrolet Venture
Feb 24, 2010 | 2001 Ford Taurus
Apr 16, 2009 | Ford Mustang Cars & Trucks
Nov 06, 2008 | 1998 Volvo S70
Jun 29, 2008 | 1988 Honda Accord 4 Door
104 people viewed this question
Usually answered in minutes!