Question about Honda Accord
SOURCE: i have a 2004 honda
there has been some problems with displays on some accord radios honda actually had a tsb on this i would call a dealer and see if your car falls in the vin range if so they might fix it for free they put a warranty extension on the applicable vehicles if yours is not covered you will have to replace the unit
Posted on Jan 31, 2009
SOURCE: my radio needs a code
"i have a 2004 honda accord my radio needs a code"
I had the same problem on my Honda Accord.
After several attempts to fix and many error messages I called a Honda house and the lady in service said "No problem". She then asked for the two codes listed by using the procedure described above (the "U" and "L" codes which both contain 4 digit numbers following the U or the L.
I gave her this and she "looked it up".
In a couple of minutes she returned with a 5 digit code which I immediately tried.
Of course it didn't work because it only has room for 4 numbers.
I went thru the battery disconnect reset (for 5 minutes) and while that was going on, I remembered that the code for the navigation system was located by another service tech once before.
All he did was pop the top off the fuse panel under the hood.
On the cover, along with the fuse identification was a white sticker with some numbers on it.
One of the typewritten numbers had a "N" written with a pen on it.
Another number was 4-digit and had a "R" in blue ink, like the N written on it.
I thought "If N stands for navigation, would R stand for radio?"
The rest is history.
When I plugged that number into the radio in the code entry mode - everything started working.
If I hadn't seen that tech open and retrieve the navigation code, I never would have related "N" and "R". The under hood fuse box is located on the driver's side up near the windshield.
Posted on May 25, 2009
needs to be removed and sent to electroic place.. bulbs are internal and cant be replaced alone. need to replace radio
Posted on Jul 19, 2009
SOURCE: Honda Accord Map Light bulb
the cover is removed straight down, slowly working it with a thin tool or butter knife. WD40 to front and rear edge (there's nothing medial or lateral). The cover has 2 Y clips on each side, one about half way, and one that clips straight off of the hinge post. There are no "tabs". It will eventually unclip straight down. Then can replace with a DE3175 LED bulb (V-LEDs.com)
Posted on Oct 29, 2009
Try 'jiggling' the key while you hold it in the start position' this could be a failed ignition switch.
It could also be that the + terminal on the starter or starter solenoid may be corroded. Since the battery was just replaced, those terminals are probably clean enough but check the negative cable where it attaches to the chassis or block. If the connection is flaky here, enough current can often pass to allow lower current devices to operate but drop too much voltage if the starter is trying to operate. Starters require 100-200 amperes, many times higher than anything else in our vehicles and show up cruddy connections pretty quick.
Posted on Nov 21, 2009
Tips for a great answer:
Feb 17, 2014 | 2004 Honda Accord
May 29, 2010 | 2004 Honda Accord
Jan 20, 2010 | 2004 Honda Accord
Oct 30, 2009 | 2004 Honda Accord
Sep 12, 2009 | 2004 Honda Accord
Apr 02, 2009 | 2004 Honda Accord
Feb 02, 2009 | 2004 Honda Accord
Jan 29, 2009 | 2004 Honda Accord
Mar 23, 2017 | Honda Cars & Trucks
Mar 21, 2017 | 1999 Honda Civic
138 people viewed this question
Usually answered in minutes!