Question about Chrysler Sebring

1 Answer

Every time I open my door my panic alarm goes off and I can't get it to stop until I pull my horn fuse and my headlight fuse

Posted by on

  • Greg May 11, 2010

    The remote key fob turns off the alarm and opens the door locks. Is it possible the battery in you remote is dead?



    One way to shut the alarm off is by using the key in the door. If you turn the key you shut the alarm and open the lock. Usually this is done if your remote is lost or battery is dead in the remote.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

ALL YOU SHOULD HAVE TO DO IS PUT THE KEY IN THE DOOR LOCK AND TURN IT ITS BECAUSE ITS ARMING IF IT DONT WORK ITS BECAUSE THE WIRING IS BAD AND U CAN PULL THE SECURITY BOX FROM UNDER THE DASH AND UNPLUG IT

Posted on Feb 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car battery got dead so I bought new battery and tried to replace the old one. As soon as I reconnected the terminals of the new battery the car started making panic horn noise. Its horn alarm goes on...


On some models you can disable the alarm after you connect the battery by locking and unlocking the driver door with the key.
I would disconnect the horn or pull the relay until you can get the alarm turned off.

Sep 25, 2013 | 1999 Toyota Corolla

1 Answer

94 VW Golf horn stays on with fuse pulled, I just got this car and tried to install a new battery when I connect it the horn sounds.I checked the fuse panel and pulled # 13 that was for the horn and it...


What your hearing is the factory alarm not the horn. Connect the battery when the alarm sounds go to the drivers door lock with the key and lock and unlock the door until the alarm goes off . Then reinstall the fuse for the horn.,

Feb 15, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

Panic alarm stopped worked


hold both the lock and unlock buttons on the key fob for about 5 seconds. (this will toggle that setting on and off)

May 15, 2010 | 2005 Nissan Maxima

2 Answers

My Mitsubishi Montero, 2003 horn is going off in the middle of the night. I beat on the horn pad serveral times until it stops, then in a couple of hours it goes off again and the police show up. Is it...


Is the alarm causing the horn to honk? If so, you need to figure out what is causing the alarm to trigger, which could be any number of things.
Or, the panic module could be failing.
It is least likely to be the horn ring unless the only way you can get the horn to stop is by "beating the horn button on the steering wheel".

If it is, then you can replace the parts for the horn button, but you will need to get an assembly manual for the vehicle. Be sure to disconnect the battery before attempting to remove the airbag module. If it goes off, then you risk injury, and, they are not cheap to replace.

Dec 16, 2009 | 1999 Mitsubishi Montero Sport

1 Answer

My alarm system is going nuts it flashes the headlights and blows the horn until the battery goes dead,or till the cops show up and make me disconnect the battery,lol it's not funny anymore (HELP!!!)only...


You have to roll up all the windows lock all the doors and use your key to unlock on of the front doors or the trunk when the alarm is going off. I don't remember which it was. Remember all doors must be closed and locked with the windows up for this to work.

Sep 28, 2009 | 1997 Cadillac DeVille

1 Answer

My horn alarm is engaged and sets when I open the door. Both remotes are broken, therefore I can't reset the alarm with the panic button. I have removed the fuse for the horn alarm to make it stop;...


LOL... MINE DID THAT ALSO ONE TIME THEN WE FIGURED OUT IF U REMOVE THE FUSE IT WONT START AND IF IT DOES IT WILL ONLY ALLOW U TO GO 20 MILES THEN IT SHUTS OFF!!! ITS A SECURITY FEATURE!!! SO IF IT EVER GOT STOLEN THE THEIF COULD ONLY GO 20 MILES UP THE ROAD!! I WOULD PUT THE FUSE BACK IN AND GO TO THE LOCAL NISSAN DEALERSHIP AND GET A NEW REMOTE!

Jun 26, 2009 | 2000 Nissan Xterra

1 Answer

DODGE AVENGER


I had a friend who had a similar problem on a Pontiac and he found out that he had an aftermarket alarm system put on and either when he locked the doors with the key and opened them with the remote or vice versa, it would do that. What is probably wrong is you have two alarms interfering with each other....

Mar 04, 2009 | 1995 Dodge Avenger

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run


Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Jan 28, 2009 | 1999 Jeep Grand Cherokee

1 Answer

1997 venture keyless remote programming


SYSTEM OPERATION

System warning lamp located on top of the instrument panel
Press UNLOCK button once , turns on interior lamps and deactivates alarm (if fitted)
Press UNLOCK button twice w/in 5 seconds unlocks all doors, turns on interior lamp and deactivates alarm (if fitted)
To activate alarm system (if fitted):
Switch ignition OFF
Open driver's door
Press Lock button on remote
Close Driver door
warning lamp will flash when system is activated
Press remote power sliding door button will open sliding door (if fitted) only if unlocked first
Pressing remote panic button:
*Sounds horn intermittently
*Flashes exterior lamps
*Turns on interior lamps
**Pressing panic for the second time OR switching ignition ON deactivates alarm.


PROGRAMMING
Remobe key from ignition switch
Remove the "BCM PRGRM" fuse, from the fuse box
Close all doors
Turn ignition switch to the ACC position
With in 1 SECOND , turn the ignition switch to OFF then back to 'ACC'
(really, with in one second)
Open and close the driver's door. A chime will sound, indicating programming mode activated
Press and HOLD LOCK and UNLOCK SIMULTANEOUSLY untill a chime sounds 2 times ( about 15 seconds)
Repeat this exact procedure for all remotes to be programmed
Remove key from ignition
Refit 'BCM PRGRM' fuse.

4 REMOTES MAXIMUM CAN BE PROGRAMMED

Aug 24, 2008 | 2000 Chevrolet Venture

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...