Question about 1986 Nissan 300ZX

1 Answer

92 NISSAN MAXIMA 3.0 dohc auto STALLING AND SURGING.

I have installed oem s/plugs. I have replaced power transitor also oem.
Added redundand grounds to air flow meter. Replaced TPS with aftermarket. I am leaning towards possible TCM.

Posted by on

  • Ed Miner
    Ed Miner Dec 21, 2008

    Has good fuel pressure so fuel filter is not the reason. Have checked all vacuum hoses as well.

  • Steve Nordquist
    Steve Nordquist May 11, 2010

    Hey, what was it? Were the cam timings off beltwise from the rest of the engine and the rotor sensor somehow working badly? I have some lurching and vibration going on, and hope it's not an engine mount! I am going to chalk it up to some issue with the transmission until I can rule that out in daylight....

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Check your fuel filter 1st or poss loose vacume hose.

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I fine the cabin filter n the Nissan sylphy


How To Install Replace Dust and Pollen Cabin Air Filter ...

? 3:02
https://www.youtube.com/watch?v=xfMfd9eDc5k
Sep 25, 2012 - Uploaded by 1A Auto Parts
http://www.1aauto.com/1A/CabinAirFilters/Nissan/Sentra/1ACAF00133 1A Auto shows you how to repair ...

Cabin air filter replacement- Nissan Maxima - YouTube

? 5:22
https://www.youtube.com/watch?v=_WgA8IYcaxU
Jul 19, 2011 - Uploaded by filterheads
Purchase this filter at: http://www.filterheads.com/AQ1093C AQ1093C This filter fits Nissan Maxima 00-03. The ...

Cabin air filter replacement- Nissan Versa - YouTube





Dec 10, 2015 | Nissan Cars & Trucks

3 Answers

Trying to find the firing order for a 2002 maxima


2002 Nissan Maxima 3.5 liter 24-Valve DOHC V-6

zjlimited_404.gif


Hope this helps (remember to rate and comment this free answer).

May 30, 2011 | Nissan Maxima Cars & Trucks

2 Answers

Oil in spark plug well 02 nissan maxima what could cause this


On the DOHC: The Spark Plug Tube Seals (Washers) on the Valve Cover has developed a leak.
Install new seals.
Remove the Valve Cover to Install the Seals.
If the Valve Cover Gasket have not been replaced recently, go ahead and replace them as well, making sure you clean thoroughly BOTH surfaces before installing any new Seal Washers and Gasket.

Let me me know if this helped, or if you have additional information or questions. Feel Free to contact me on FixYa.com!

ps...I'm replacing (for free!) the Valve Cover Gaskets today on a 1994 Nissan Maxima. Looks like we both will have fun!
If you need the Valve Cover Torque Sequence / Specs let me know on the Comment Section of this Post.

Apr 12, 2010 | 2002 Nissan Maxima

1 Answer

How to identify engine.


THERE IS A PRODUCTION NUMBER STAMPED ON THE BLOCK THE 4TH OR 5TH NO WILL BE THE YR AND WHARE IT WAS MADE

Feb 26, 2010 | 1992 Nissan Maxima

1 Answer

Where is the thremostat located on the motor


2002 Nissan/Datsun Maxima 3.5L SFI DOHC 6cyl

c3b3752.gif

Fig. View of thermostat and components


dcc6d68.gif

Fig. View of thermostat and components-2002-2006 Maxima

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove or disconnect the following:

    Negative battery cable If equipped, engine cover On 2002-2006 Maxima, air duct and air cleaner case On 2002-2006 Maxima, drive belts Water drain plug on water pump side of cylinder block Lower radiator hose Water inlet and thermostat assembly
  4. To install, reverse removal procedure
  5. Install thermostat with jiggle valve facing upward.
  6. Run engine and check for leaks

Good luck (remember rated this help).

Sep 12, 2009 | 2002 Nissan Maxima

2 Answers

My 1992 Nissan Maxima is sputtering upon acceleration. It has 220,000 miles on it and it seems to mainly have this problem in first gear. And mostly happens shortly after starting the car. Ive done a basic...


92 max
I own a 92 max 370 kms runs good but one day just cuts out while doing about 30 km, I pull over i can start it no problem but when I touch the pedal to accelerate the car stalls out.

It got worse to the point of sputtering on the highway , sometimes i could keep it alive by working the pedal but others would slow down and stall out.

I have changed the fuel filter and plugs seemed to make it a bit better but still stalling. I ran it in my driveway for 10 mins on idle then it stalls out

Is this the fuel pump??

Jun 13, 2009 | 1992 Nissan Maxima

2 Answers

1992 SE maxima jerking, sputtering, stalling


I had a similar problem and resolved it by replacing the mass airflow sensor. Ive got 235k+ miles on my 1992 Maxima SE.
Still runs good but having problems with the alarm system.

Jan 27, 2009 | 1992 Nissan Maxima

1 Answer

92 Maxima Putters and sometimes even no gas sometimes


Yes I can help you. Change your coolant temperature sensor and all will be well. Only use Nissan, Bosch, or NGK part.

Nov 14, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...