Question about 1998 Pontiac Grand Am

1 Answer

Were is the ignition modual at ?

I dont know what it looks like or were it is can some one pleas tell me

Posted by on

  • linkinparkbr Dec 21, 2008

    its a pontiac gran an 1989 2.4l twin cam

  • autopop May 11, 2010

    On what car and what year?????



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

It's on the bottom of the camshaft cover right next to the coil housing. It is what the electrical connector on the drivers side plugs into.

Posted on Jan 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Will crankshaft sensor make 2003 Buick century with 3100 (3.1) engine not crank?

Crank sensor only tells the ignition modual what position the motor is in. If it's not cranking you may have a starter solenoid or starter going bad, bad battery, or other electrical issue, could even be a bad ignition switch.

Jan 23, 2015 | Buick Century Cars & Trucks

1 Answer

2000 mercury couger key not picking up modual

The ignition module won't read the key or the module
by the instrument panel may not be working, if
that applies.

Your going to need a dealer or repair shop to scan
the system

A code reader won't do that.

Sep 11, 2012 | 2000 Mercury Cougar

1 Answer

Why would my 1992 chevy suburban get no sprark

check inside distributor cap for wear and center of cap there is a carbon button that contacts rotor look carefully at that.make sure wires to distributor tight.if looks good remove ignition modual from bottom of distributor(black sorta retangular)most part stores can test it for small fee.those moduals with fail without warning.

Feb 15, 2011 | Chevrolet Suburban Cars & Trucks

1 Answer

I Have a 2001 chevy blazer v6 4x4. I have had the car myself and pretty good with cars. I got a call while i was out of town saying your car that the blazer wont start. that is all the infromation i get. I...

if you have no spark remove distributor cap and check rotor and cap contacts.look for white lines going from contacts to hold downs.if looks ok remove ignition modual from inside distributor(littlle black sorta rectangular)most parts stores can test modual for small fee,they are a common failure with no warning.also better of to squirt gas into intake to test starter fluid bad stuff!

Feb 15, 2011 | 2001 Chevrolet Blazer

1 Answer

Need to know which collor wires go to the powertrain control modual

The man on the assembly line ?? I dont think any mechanic would know offhand,look at one in the scrapyard is the best answer here i think

Oct 23, 2009 | 2001 Chevrolet Cavalier

1 Answer

My 1978 ford bronco dies and doesnt want to restart. The motor has 2000 miles on it. It has a new electric fuel pump,coil distributor, cap,rotor, wires, plugs. it does the same exact thing with 2 diferant...

Float could be stuck, if it's carbureted or gasket under carb could be loose. Tighten and also put new filter in it. Could be bad injectors, if it's EFI which I doubt knowing the year. Could be choke setting wrong. I like manual choke myself. Try starting it with something holding choke open like a screwdriver handle. Something not too flammable.

Jun 25, 2009 | Ford Bronco Cars & Trucks

1 Answer

Van turns over but will not start

Try spraying some starter fluid down the intake and see if that will help it start. If it does start that tells you that it is a fuel related problem and you can go from there. Let me know what you find out and I will see if I can help some more.

May 07, 2009 | 2003 GMC Safari

2 Answers

My transmission appears to be slipping from gears

first check the level of the tranny fluid the truck needs to be running and in nutral if you have fluid it is probably the modual,the shift control modual comonly goes out the dealer will tell you you need a new transmission take your truck to a good transmission shop and have them check the modual tighten the bands and flush the transmission I had the same problem and that fixed the problem, the cost was around 350.00 also check to make sure that you dont have any leaks in your tranny lines. hope this helps

Feb 27, 2009 | 2001 Dodge Ram 2500 Truck

2 Answers

92 buick lasabre periodicly stops running while driving

This can be caused by the fuel pump going out to. once you lose fuel into the intake it will automatically shut the car down instantly.

Feb 20, 2009 | 1992 Buick LeSabre

Not finding what you are looking for?
1998 Pontiac Grand Am Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides