Question about 2002 Jaguar X-Type

2 Answers

Where is the mass air flow sensor located on a jaguar x-type

I need to locate the mass air flow sensor on the jaguar's engine.

Posted by on

  • 1 more comment 
  • Anonymous Mar 16, 2014

    not breathing right gunk in oil cap

  • Anonymous Mar 18, 2014

    mass air flow sensor

  • Anonymous Mar 31, 2014

    Need to know where the temp gauge sensor is located in the engine

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 566 Answers

Hi from the uk the location of mass air flow sensor on x type jag is as follows==it is on the r/h/side of the air filter cover with jaguar embossed on top? this sensor is just prior to the intake hose that connects to the motorised throttle body from filter connections underneath it to unplug and meter is held by two screws ?if memory serves ? may i suggest you remove the large hose and use a little wd40 or similar to clean /lubricate the throttle butterfly in throttle body throat at this point so as to prevent future sticking upsetting of idling ? hope this helps ?

Posted on Dec 20, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the ambient sensor on jaguar x type 03 Reg?

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What does MAF mean


MAF stands for Mass Air Flow. Your MAF meter is located in the inlet snorkle between the air filter housing and the throttle body.

Jul 09, 2014 | 1998 Ford Expedition

1 Answer

Co emission reading 5.96% whats wrong


you need to get the fault codes out of the engine control module to help with this one, the favourites are. 1 lambda sensors, 2 catalyst, 3 water in engine control module located rh lower A post due to water ingress,would be good if you monitor live data with diagnostic equipment. could also be mass air flow sensor or fuel pressure

Oct 17, 2013 | 1995 Jaguar XJ6

1 Answer

What are an m.a.f and an e.g.r on the jag 2.0d


m.a.f is mass air flow, sensor located in induction pipe near battery,check wires at sensor connector as these are prone to braking.E.G.R. is exhaust gas recirculation.valve located at left front of engine as you look under bonnet and are prone to getting clogged and sticking, may need renewing, failure causes excess exhaust smoke.

Mar 31, 2013 | 2004 Jaguar X-Type

1 Answer

Were is the intake air temp sensor located on a 2001 chrysler 300m


P0112 is the code for a intake air sensor problem. If you can buy one seperate it will be located between the Air filter and the Throttle Body ... usally near the Mass Air flow sensor . I am a Jaguar Tech our are located inside the Mass Air sensor . Also ck the actuall housing of the air filter assembly

Aug 05, 2012 | 2001 Chrysler 300M

1 Answer

I have a 2003 Jaguar S Type V6 and I wanna know how do you know if you need to replace the mass air flow sensor or whatever! I have changed the plugs and coils on it all ready cause it was starting rough...


Rather than take a stab in the dark replacing items - get the codes scanned and this should show what area the fault lies in. Normally if there is a fault with the MAF (mass air flow meter) it would normally show as a check engine light (MIL) - is this warning on? So many things can affect these engines from O2 sensors, coil misfires, bad cable connections etc etc. - so best move get the car scanned. Hope this helps (and saves money) good luck.

Mar 09, 2011 | 2003 Jaguar S-Type

1 Answer

Does a 1996 Ford Taurus 3.0 have a hot wire type mass air flow sensor or a vane type? Would spraying carb cleaner into the MAF fix the problem of hard cold engine start? Once the engine warms up does the...


TheMobilian, Yes, the Mass Air Flow is a Hot Wire type. There is a spray made for the mass called mas air flow cleaner. Regular cab cleaner is too harsh and can eat the coating inside mass air flow and it's delicate parts. Use throttle bore foam cleaner; it works like bathroom scrubbing bubbles and eats the gum and varnish. When engine warms up (closed Loop) both sensors work together giving input to ecm for output. Have someone with a live data reader read both sensors. (Let me know the readings?)


Image Mass Air Flow(MAF)Sensor

PURPOSE

The Mas s Air flow (MAT) sensor measure s the amount of air flowing into the engine.

This value is used by the Powertrain Control Module (PCM) in calculating the required

Fuel injector pulse within order to provide the desired air fuel ratio. This input can also

be used in determining Electronic Pressure Control (EPC). Shift and torque converter

clutch scheduling.

CONSTRUCTION

The MAE sensor is located directly in the airflow path between the air cleaner housing

and the throttle body. Ail air entering the intake manifold must pass through the sensor.

Located in the MAT sensor directly in the airstream are two platinum wires, a hot wire

heated by electrical current and a cold reference wire. The MAF sensor uses the air flow

across these wires to calculate its output.

OPERATION

The hot wire is maintained at 200CC (392CF) above ambient temperature as measured by

a constant cold *e. The current required to maintain the temperature of the hot wire is

proportional to the air mass flow. The MAE sensor then measures the amount of

electrical current required to maintain this temperature difference and converts this

value to an analog DC voltage. This output varies directly with the mass air flow rate.



Pay attention to the Paragraph about the torq converter.


Dec 17, 2010 | 1996 Ford Taurus

2 Answers

Location of mass air flow sensor, 2000 Grand Prix GTP


Hi:
The mass air flow sensor is a round sensor that is mounted in the air intake, between the air cleaner box and the engine throttle body.

Feb 07, 2010 | 2000 Pontiac Grand Prix

3 Answers

Need to know what MAF means.


MAF stands for mass air flow sensor, this is used to tell the computer how much air is entering the engine, check the air filter,and clean the sensor with CRC mass air flow cleaner, with engine off. hope this helps,let me know Ray

Apr 13, 2009 | Nissan Maxima Cars & Trucks

Not finding what you are looking for?
2002 Jaguar X-Type Logo

2,987 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...