Question about 2003 Mitsubishi Outlander
I saw your post and was wondering if you still have that image of how to remove the ac control dash unit on a mitsubishi outlander?...my email is email@example.com .....any help you can give me would be great...I got the new controller unit, just not finding any info on how to remove the old one without tearing up my whole dash...thanks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: serpentine belt replacement
The routing diagram is under the hood.
Posted on Dec 14, 2008
TAKE A PEEK UNDER THE HOOD IN THE FUSE PANEL FOR THE FUSE AND RELAY FOR THE COOLING FAN. IF THE FUSE IS BLOWN THEN REPLACE IT. IF YOU SUSPECT THE RELAY TO BE BAD THEN TEST IT BY SWAPPING THE FAN RELAY WITH ANOTHER ONE WITH THE SAME PINS ON THE BOTTOM. MAKE SURE IT IS THE SAME SIZE AS WELL. HOPE THIS HELPS.. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK
Posted on May 16, 2009
there is a recall on the cooling fan controller you can call a local mitsu dealer tell them your vin to see if you are covered under the recall
Posted on Jul 02, 2009
No your radiator has gone bad and needs to be replaced.
It is a radiator with crimp on takns, and the seal has gone bad.
All you can do is have it replaced.
And please dont keep driving the car till you get the radiator replaced, or you could easily overheat and destroy your engine.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
Posted on Nov 08, 2009
Dear Brake Drum Remover,
I'm gonna tell you how to pull this drum off, ya ready?First off, get the rear of the vehicle up in the air safely, Then pull the rear tires off.After those are off then take a gander at the face of the drums, are there shiny brass looking screws installed on the face of that drum?Ifso remove those counterclockwise, then, take a hammer a shock the face off the drum firmly about three times.Now, go to the opposite side on the face of the drum and do that again, keep on doin that until you can wiggle the drum off by hand...easy as that, any other questions get back to me. I'M HERE TO HELP!!!
Posted on Nov 21, 2009
Tips for a great answer:
Oct 23, 2012 | Cars & Trucks
Sep 08, 2011 | 2003 Mitsubishi Outlander
Jan 13, 2011 | 1992 Plymouth Voyager
Nov 23, 2010 | 2003 Mitsubishi Outlander
Jul 28, 2009 | 1998 Volkswagen Beetle
Sep 28, 2008 | Hyundai Motor 2003 Elantra
Jul 07, 2008 | 2005 Kia Spectra
148 people viewed this question
Usually answered in minutes!