Question about 2001 Chevrolet S-10

1 Answer

Blower motor only works on high - 2001 Chevrolet S-10

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

That would be a blower resistor problem. Very common problem on GM vehicles. The resistor is mounted in the heater case right next to the motor. Follow the wires going from the blower motor and they will go right to the blower resistor. There are usually 2 screws holding it to the heater case. Also know that GM had a problem with the plugs melting so check it carefully and replace it if needed. Good luck.

Posted on Dec 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater blower only works on high


Most likely the blower motor resistor or the fise for the low speeds. The high setting for the blower motor is on a separate circuit than the other lower settings.

Dec 04, 2013 | 2008 Chevrolet Hhr

1 Answer

Blower motor always high front and rear


look in the fuse panel there is a fuse for blower high and blower low check the one for blower low the location is on the inside of the fuse box lid

Mar 27, 2013 | Cars & Trucks

1 Answer

98 buick heater stop working


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Dec 14, 2012 | 1998 Buick LeSabre

1 Answer

Sorry its blower



Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Dec 07, 2012 | 2006 Kia Sportage

1 Answer

Heater is not working


HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | 1988 Honda Accord 4 Door

1 Answer

Blower motor only works on high


This is a problem that is due in every case to a failed blower motor speed control resistor. the blower motor resistor is located right next to the blower motor and the wiring harness connector sticks out of the air ducting that cools it.

Sep 27, 2012 | 2006 Mitsubishi Galant

3 Answers

I only get the fan to work on high speed, the lower speeds do not work


Hi!!
The Blower Motor Resistor also called Manual Temp. Control resistor), is fried, replace. The price with floor console $25 and without floor console $65. here is a pic.
87b9810.jpg

the resistor is located on the blower motor housing, fastened by two screws. It is the part where the electrical plug connects, the plug on the pic. goes to the blower motor.
A HELPFUL - 4 THUMBS rating for this solution would be greatly appreciated. Thank you for using FixYa.

Oct 19, 2010 | GMC Yukon Denali Cars & Trucks

1 Answer

What's causing my 2005 E-250 blower motor not to work.


does the motor not work at all or only on high setting? if only on high setting, i would recommend replacing the blower motor resistor. if it does not work at all, i would check the blower motor fuse first, if that has power, i would unplug the blower motor, key in run, and turn the fan on, then check for power at the blower motor connector, then check for ground, if both present, then replace the blower motor.

Oct 24, 2009 | 2004 Ford E250

1 Answer

AC is stuck on high on my nissan titan 2006. I have heard it may be the resistor or the control panel


The blower resister is near the blower motor,mounted on the outside of the blower box,but actually goes inside the blower box.It~s function actually is to give the blower motor lower speeds.If it is only working on high,then this is the problem.If it works on high when you select a lower speed,then there is a high blower motor relay that is stuck in the closed position .Replace the relay.

Sep 09, 2009 | 2006 Nissan Titan

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...