Question about 2002 Saturn VUE

1 Answer

Both break lights are out

Both break lights are not working - not sure for how long. I have had front brake and rotar replacements about 4 weeks ago. Not the fuse or bulbs.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 129 Answers

There is a brake light switch it is located under the dashboard

follow your brake pedal up into the dash were the pedal pivots u will find the switch push the pedal with your hand to see if u can find it
it will have 2 wires on it u will have power on one side only when u push the brake pedal u should have power at both wires

some switches can be adjusted if not replace it

see how u go mate

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 buick rendevous. I skidded up to a


The pads should have been renewed when new rotar ,s were fitted,check anti squeal plates are still on the back of pads.

Sep 30, 2014 | 2004 Buick Rendezvous

1 Answer

Brakes went out


Have you checked the master cylinder for leaks and around the brake booster? You may have a bad brake light switch.

Jan 21, 2014 | Lincoln Navigator Cars & Trucks

1 Answer

Suddenly, No tail lights, brake lights, turns signal or back up lights At 83000 miles, 6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen...


just look for the blackened/burned pin on the rear light plastic connector and sand it down to re-establish a good electrical connection and save yourself $800 big ones on replacing the multiswitch.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

Right front brake is locking. Was replace 1 week


Make sure that the brakes were bleed correctly. Check the caliper it might be starting to go.

May 12, 2010 | 1999 Jeep Cherokee

3 Answers

How to shut off Brake wear sensor after pad change


If the brake pads were worn enough to activate the warning light the sensor or sensors must be replaced. There is no reset for this.

Oct 24, 2009 | 2004 Lexus LS 430

1 Answer

2005 mazda tribute....abs problem


a speed sensor on the front,have the ABS system scaned for the codes(this will show you wich sensor is bad)

Sep 08, 2009 | 2005 Mazda Tribute

1 Answer

2004 grand am (red BRAKE light/ABS/Service Vehicle Soon/Trac Off)


Hey I had the same thing on my car!! I replaced both front wheel bearings and it took care of it!! I have a 2003 grand am se. it will set you back around $120.00 a per a side!!!

Apr 14, 2009 | 2001 Pontiac Grand Am SE

1 Answer

04 A4T brake problems


The brake calipers don't seem to be relesing all the way you might have to replace them or try to get a brake bleeping service and see if that helps them out. Does it pull when you hit the brakes?

Dec 04, 2008 | 2004 Audi A4

Not finding what you are looking for?
2002 Saturn VUE Logo

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...