Question about Saturn SL2

1 Answer

What does it mean when you are losing power and a SWITCH TO D2 light comes on?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 393 Answers

Switch to 2nd gear

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wrench light comes on and car loses power. no codes being read


When you say loses power, if you mean it acts like it is turning off, you probably have a bad crankshaft or camshaft position sensor. When these fail they don't always throw a code. They do fail intermittently sometimes, then start working again.

Nov 13, 2015 | 2007 Lincoln LS

2 Answers

Brake light stop working


I can't imagine three brake lights all losing their grounds. You will need a volt meter to check (with the help of an assistant) to see if about 12 volts is available at the bulb socket's brake light socket (as measured to ground) when the brake pedal is depressed and held. Do the same for the other light and finally the third brake light. If there is a total loss of power at all the bulb sockets with the brake pedal depressed and held, check for about 12 volts coming to the brake pedal switch while not being depressed and that voltage comes out the other connection at the switch when the brake pedal is depressed. If power comes in on one wire but doesn't come out the other side when pressing the pedal this means the switch is bad. Replace it with a new one. Ne advised that SOME vehicles brake lights don't come on if the key is off, on most they work at all times even if the key is off.

Jun 02, 2014 | 2002 Chevrolet Impala

1 Answer

Dome light does not come on fuses good


first test the bulb. Use a multimeter to test the bulb. http://youtu.be/f7ltMwaKx2I
If that checks out ok, then take the dome assembly off and check for power at the wiring harness while the doors are open and or the switch is on located on the dash. If you do not get power it means it can be the switch in the dash or a faulty component that causes an open door to turn them on.

Feb 17, 2014 | Chevrolet Cars & Trucks

1 Answer

Check engine oil pressure light coming on and causing engine to die. After 5 minutes, no light and no engine trouble.


Yes I would say the oil pressure switch is faulty. The oil pressure gauge uses a different sensor, so if the gauge did not drop but the warning light came on, I would have the warning light switch checked. If the warning light comes on, the fuel pump will stop getting power and you will lose fuel pressure too.

Jun 27, 2013 | Cars & Trucks

1 Answer

My dashboard warning lights keep coming on and i loose power steering


which light, there are many.
my guess is you mean ,charge and CEL/SES lamp comes on.
That means the engine stalled.
and when that happens , engine power ends, P/S ends and after 2 braking actions you lose Power brakes. (manuals always work but are heavy size foot needed)

Jun 20, 2013 | 2005 Suzuki Reno

2 Answers

92 honda accord ex - No power on D4..


D4 is slipping and not engaging. This means you need a transmission. you're losing a gear

Jul 24, 2009 | 1992 Honda Accord

1 Answer

92 saturn sl squeals and loses power


the shift to d2 light comes on when batt. voltage gets low enough that all of the sytems can not function properly. the noise is your bel slipping, your battery looses charge and shift to d2 light comes on to tell you to leave trans in drive 2 so it dose not have to use batt voltage to shift. replace your belt and tensioner if your alternator is ok.

Mar 24, 2009 | 1992 Saturn SL

1 Answer

SWITCH TO D2 LIGHT/LOSS OF POWER


Check your alternator. Our car had the same thing and it was due to the alternator malfunctioning. Once replaced, we got no "switch to D2" light

Dec 20, 2008 | 1992 Saturn SL2

4 Answers

95 montero sr


Do all the warning lights in the instrument cluster come on when you turn the key? If Yes, then you need to check the neutral safety switch on the side the transmission[Automatic in your Montero?], as these are a known failure part for higher mile Monteros. You lose power to the starter solenoid as a result of the switch contacts going bad. Have someone put a test light on the solenoid wire at the starter motor, while you or a friend carefully tries to start the engine. If the circuit is working correctly, you'd see the test light turn on brightly. I'm betting you'll see no light, since I suspect the switch isn't letting power through.

Sep 04, 2008 | 2007 Mitsubishi Montero Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...