Question about 1999 Audi A6

1 Answer

01 a6 avant

Hesitation when taking off from start, lift off the pedal and press again and it goes great. I have put a new throttle body , cam sensor and have been thu 3 differrent audi shops help please no more $$$$$

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 8 Answers

DID YOU CHECK THE AIR FILTER, FUEL FILTER & PUMP RELAY?

Posted on Jan 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok...I have a 2010 Camaro V6. I threw a code for cylinder one misfire. I bought a spark plug...same code. Switched coil packs...same code along with throttle body. So I bought a new throttle body...same...


throwing parts at is a waste of money. misfire can be one of 3 things. cam sensor or crank sensor or fuel injector. other things can can be a air leak too much air in the intake or leak in vacuum line. can also be the timing is out.. this can be the adjuster weak.

Mar 04, 2018 | Cars & Trucks

1 Answer

01 Kia Spectra When I start it cold it stays high idle. Have to press the accelerator to bring down the idle When shift into gear it hesitates to go It feels like it wants push gas through but putters


Ok that to me sounds like you need to clean the throttle body it easy buy carburetor clean just srap a little inside the throttle body n clean it that will help you the problem is the trottle body gets dirty sticky and won't idle good n stall remember don't put to much. Just a few spats inside the when you put the hose back it might take a few minutes to start because of the amount also don't accelerat it to high when it start good luck

Oct 03, 2015 | Kia Cars & Trucks

1 Answer

I have a 2002 LW200 wagon with L61 Eco-tec. I installed rebuilt engine. Put back old IAC. I checked pintal to make sure it was 20MM. Engine starts great but idles at 2300-3000. After a few seconds the...


throttle position switch sounds like getting false readings to computer,
incorrect volts or excessive play from the throttle plate or sensor causes this,has to be one or the other,also check for any intake leaks from the filter to the throttle body,good luck,Gary

Oct 24, 2013 | 2002 Saturn L-Series

1 Answer

1997 Plymouth Voyager 3.3 dies at idle hesitates during acceleration


It should show up with a P code as it misfires. If it doesn't, check the engine temperature sensor and O2 sensor.

Mar 01, 2017 | Cars & Trucks

2 Answers

The engine light comes on and the reduced power is activated ,there sensors were tripped all to do with the throttle . the auto shop ended up replacing the throttle body and the problem just happend again...


I'd bring it back to the shop that put in the throttle body and have them check to see if the replacement was defective or failed. If not, you may have a bad throttle position sensor [part of the gas pedal] I'm assuming it worked fine for a while after the repairs with no problems then suddenly started acting up again. I've replaced a bunch of throttle bodies but only one position sensor so far. There's always the chance that there's a bad wire somplace or some other more exotic problem but I'll bet you'll find it at either the sensor or throttle body. Good luck, hope this helps!

Aug 01, 2010 | 2003 Chevrolet Avalanche

2 Answers

I have a 95 mercury mystique and it starts but but


THE ENGINES THROTTLE BODY HAS A TPS WICH IS CALLED A THROTTLE POSITIONING SENSOR

It has a built in reostat inside of it which can get a flat spot anywhere in its circuit explaining why your car hesitates or sounds like it is ready to stall out
'
I would replace it and have the voltage set at 1.5 volts when set at the idle position
Then it should run fine again

Apr 10, 2010 | 1995 Mercury Mystique

1 Answer

Fuel delivery s10 blazer


Did you change the fuel filter?

Mar 25, 2009 | 2000 Chevrolet Blazer

1 Answer

Hard to start and flooding of my 96 jetta diesel


O-2 sensor what is the cause of that, it is the one on the side of the throttle body in your book on the car it will also say Oxygen sensor, change it out it will be fine, The Jetta is a great car take car of her

Feb 22, 2009 | 1996 Volkswagen Jetta

Not finding what you are looking for?
1999 Audi A6 Logo

Related Topics:

191 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Marvin
Marvin

Level 3 Expert

81285 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14423 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...