Question about 1992 Buick Park Avenue

2 Answers

1992 buick park ave ultra

The car runs fine for awhile and then starts to hesitate and stall when I accellerate. I have changed the spark plugs and wires and have changed the fuel filter twice since I got the car. I've put premium gas in it and I have also tried different additives. Can't figure out why I starts shaking and stalling when I put my foot on the gas.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

And it could also be the fuel pressure regulator
I had a 2000 windstar that would be hard to start then would sometimes me stalk when the gas pedal was depressed..turns out it was a bad fuel pressure regulator
Good luck

Posted on Oct 31, 2017

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 8,841 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

huuum
  • 750 Answers

SOURCE: stalls out

lisalavin,

You said,

My 1990 Buick century stalls out when in park after idling for a minute or two and stalls out when brake is applied. last night it did this every time I had to stop or make a slow turn it also started shaking a bit but if i released gas a little bit it would stop. i thought the shaking might be the cvu joint as it needs to be replaced but it started doing it on straight aways and hills also but would still stop shaking if gas was eased up on. Closer to home when it was stalling the only way I could get it to stay running while I put it in drive was to have one foot on the brake and the other on the gas. Is this a matter of changing the fuel filter or is it something more complicated?

It can be one of many things causing this!
1. Low idle, needs to be raised
2. A vacuum leak, needs to be diagnosed.
3 The choke, if it's when it's cold or the engine is cold and not up to running temp.

4.But, I'll l bet it's a idle sensor

Or last and probably NOT a broken baffle in the cat converter!
this usually happens more often not just with the stop but even when driving!

Bless you,
huuum
You really need a good honest HANDS on diagnoses!

please give me a god rating before you sign off


Posted on Sep 12, 2008

  • 4 Answers

SOURCE: 1992 buick park ave

have you replaced your ignition module?

Posted on Oct 04, 2008

  • 8 Answers

SOURCE: Car starts then stalls out...

could be to many thing to take chances with, but most commonly;fuel filter,gas line antifreeze or a crack in your air intake which would take your vacuum seal away, start with the least expensive and work from their. Worst case scenario pinched fuel line

Posted on Jan 19, 2009

emissionwiz
  • 83081 Answers

SOURCE: 1999 buick park ave ultra 3800 supercharged.Car

a very common issue on these is the crankshaft position sensor, it is sensitive to heat when it goes bad, had the issue on my own Buick.

Posted on Mar 10, 2009

frcs68
  • 1605 Answers

SOURCE: 1995 buick park ave bucks/shakes

it may be fuel injector wiring. since you have check the compression and the replaced the injector. it is time to take a look at the injector wires.

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 park ave ultra is hesitatating when I start using the gas as I start an incline mostly but sometimes just randomly an it's getting worse


Engine Stalling Due to Mass Air Flow/Crankshift Position ...

repairpal.com > Problems > Buick > Park Avenue
Buick Park Avenue Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor Failure. This is a verified ... 1997 Buick Park Avenue- 3.8L V6160,000Visitor. Engine stalls ... car runs then stalls and won't start for thirty minutes. Upvote (36).

Buick stuttering Questions & Answers - Fixya

www.fixya.com > Forum > Tags > stuttering
94 Buick Park Avenue that stutters under a light load I have a 94 Buick Park Avenuethat ... Buick Century 97 runs rough and stutters when cold and gas applie Engine runs rough ... I have a 1994 buick lesabre it starts ok but stutters and stalls.

Oct 30, 2015 | Cars & Trucks

1 Answer

I have a 98 Buick Park Ave Ultra. It's a slight


If the light is on the engine computer will have a trouble code or codes, which may help you towards solving the problem. Have the computer scanned for the codes. Go from there. Good luck.

Feb 21, 2012 | 1998 Buick Park Avenue

1 Answer

1991 buick park ave ultra their is loud sound by the starter area, it starts up fine no hesitation or whistling sound.


The starter drive may be staying engaged. Don't start or drive it until you have it checked-out, as it could also ruin the matching teeth on the flywheel. Replacing this would require removing either the transmission or motor.

Apr 14, 2011 | 1991 Buick Park Avenue

1 Answer

92 Park Ave stalls, no codes..!


Sounds like the ignition module that sits under the coil packs ... did you ever get any codes out of it when the light was on ?

Jul 29, 2010 | 1992 Buick LeSabre

1 Answer

I have a 1994 buick park avenue ultra that stalls out at regular running temperature when I'm at a complete stop and begin to pull off ! After it dies once and it doesn't start and blows another fuse I...


I have a 94 buick park avenue ultra for 3 yrs. and it started stalling out. Going on line, some people replaced most sensors and gas filter. My problem was vacuum lines that were shot and one, going yo the fuel pressure regulator wasn't connected, which was the main problem.

Jul 17, 2010 | 1994 Buick Park Avenue

3 Answers

I have a 1995 Buick Park Ave Ultra. The car has power but will not turn over. I was told by one shop that it might be the V.A.T.S. system and by another that it is the IGNITION CONTROL MODULE.


Make sure the battery cables are clean and tight on the battery. Check to see if the wires to the starter are tight. Try starting it in neutral to make sure the safety switch is being make. Also hold it up into park and try.

Mar 22, 2010 | 1995 Buick Park Avenue

1 Answer

93 buick Park ave ultra wont start. Turns over fine, but wont start. Was sitting awhile, 2 months. Ran o/k before that.


make sure there is gas in tank. turn ignition switch to the on position.listen for fuel pump.if yes check for spark at plugs.if no you dont hear fuel pump.check fuse and relay.if both dont work.scan it to check for faulty crankshaft sensor fuel pump and pcm.

Jul 18, 2009 | 1996 Buick Park Avenue

1 Answer

After 20 miles or so the car overheats and shuts off but once it cools down its fine again


The ignition module in located in the distributor under the cap. Might contribute to the stalling ,control spark to spark plugs, timming advance etc, but has no bearing on overheating. Hope this helps.

Apr 15, 2009 | 1992 Buick Park Avenue

3 Answers

95 Buick Skylark Stops Running


the fuel pump is slowly going out

Dec 01, 2008 | 1995 Buick Skylark

Not finding what you are looking for?
1992 Buick Park Avenue Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

Marvin
Marvin

Level 3 Expert

83081 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...