Question about 1998 Ford F150 Regular Cab

2 Answers

How to remove drivers side door pannel

How do i remove my door pannel

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 82 Answers

It is held on by little plastic clips. grab hold of one of the corners and give it a steady tug to pop one of the clips loose. Follow along the rest of the panel but be sure to unclip the wires to the window switch and lock switch before yanking the panel away. If the clips are still reusebale which they should be, they should be in the door itself use a fork to pry the clips out and replace them in the panel to put the door panel back on after you are done working.

Posted on Jan 05, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 337 Answers

6 Suggested Answers

onyeredson
  • 404 Answers

SOURCE: How to remove the front door driver side pannel / molding?

Hi Leon, I have a E34 1995 5 series and had to take door cards off. They're predominantly held on by plastic button clips around the edge/circumference of the door card HOWEVER there is a couple of screws hidden, 1 is behind the chrome door pull/lever a little round plastic cover hides it the other is behind the top of door handle maybe on yours behind door mirror electric adjuster button. one scew is philips the other Torx when pulling the card off the clips try a large flat/wide implement to prise it away as you may breaks some of the clips (£2/3 eBay) One more thing the door handle locates into a grip from behind you'll need a long screwdriver to push the tang up to release it. All the above should be well similar to your model. Oh! nearly forgot remember to unscrew/take off the door pin that goes up and down when locked/unlocked
Good luck!
Paul 'W'
Onyer~EDson(:0)~[><

Posted on Dec 04, 2008

  • 9 Answers

SOURCE: replace drivers side mirror

They have kits you can buy to remove the door panel but when you do it, be careful and go slow, make sure not to break off the clips on the door panel otherwise it wont fit right when you want to put it back in. im not so sure about the mirror though.

Posted on Jun 26, 2009

  • 318 Answers

SOURCE: 2002 Toyota Rav4 remove door panel

There are some hidden screws around the door handle but you get under the panel and yank hard to pop the fasteners. Also remove the black piece behind the mirror. Alot of times it is seperate. 3 screws behind that and the connector and you are done.

Posted on Jul 22, 2009

  • 4 Answers

SOURCE: Lincoln Town Car 1999 driver side window switch

I have the same problem in my 2001 towncar. I removed the switch control panel (without removing the door panel) by prying up from the front of the panel. There's a spring loaded plug under the mirror adjustment. Once you get that pulled up, the whole unit will lift out. Since there's a two year difference in the models - it MAY not work... however, you might not have to remove the whole door panel as you think.
In my case, the wiring was bad.

Posted on Sep 03, 2009

  • 248 Answers

SOURCE: cannot get the drivers door open, manage to remove

u must get to the lock assy to unlock the door

Posted on Mar 09, 2010

honeymokey
  • 3113 Answers

SOURCE: how do i remove the door pannels

remove the screws for the catch all box ot the bottom of door, remove the window switch and the two hex head screws that hold the door panel on under the switch. remove the screws under the arm rest and remove it. When that is done it just un snaps from door

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Basic instructions on how to replace drivers side inside door handle on 1997 Chevy 1500 truck.


1. remove the triangle at the front of the window
2. remove the trim around the inside door handle
3. with the surround removed - pry the switch in the door up -it is connected with pressure seals- if u get a screw driver under it and push up- they will pop out as u go around the edge of it .leave the switches connected to the wiring since u have to put the window down in a little bit
4. remove the 2 screws in the door handle here they are starting to come out
5. put the windows down about a half inch or so....this will get easier to get the door handle bolts
6. using a door pannel tool disconnect the pannel from the door. you may break some of the pannel connectors so you may want to have a few replacements on hand for this
7. when the door pannel is loose enough to take off (don't remove it yet)- disconnect the wiring from the window/lock switches at this point
8.disconnect the courtesy light from the pannel
9. remove the plastic door pannel from the door and set it aside.

Dec 20, 2011 | 1997 Chevrolet K1500

1 Answer

The lock has fallen inside the driver's side door


Here is a common way to remove your door pannel:

1st, find the screw that is attaching the inside door handle (looks like an armrest) to the door panel. remove this screw. there is also a screw located at the door lever (the device you use to open the door from the inside). remove this screw. after this, slide your door panel up to remove it.

Aug 10, 2011 | 2007 Chevrolet Aveo Sedan

1 Answer

Where is the fuse box?


open the driver side door, and there should be a pannel on the side of the dash you can remove fuses are under pannel.

Oct 27, 2009 | 1996 Chevrolet Blazer

1 Answer

HOw do remove the drivers side door pannel on 2004


review this information:
- WJ Section-23-Body-ewj23S (page 34 and next)

For other Sections about WJ Service Manual, visit WJ 2000-2004 Service Manual

I really hope help you (remember rated this help) Good luck.

Sep 29, 2009 | 2001 Jeep Grand Cherokee

2 Answers

In my 1996 toyota 4 runner my driver side door opens only from the inside. The locks still work and it still opens but not from the outside. How can I fix it?


you have to remove the inside door pannel first remove the arm rest two screws then remove the door latch assembly then remove the crank handle by removing c clip around the wndow knob unless electric, next pop the lower and side screws out of the corners then pop the snaps up from the door remove the lock tab at top pull pannel next gently remove the plastic that covers the door and straighten the rod out on the inside that goes to the outter door handle, if it's not hooked up then you will have to buy a plastic clip from toyota to replace it with.

Aug 14, 2009 | 1996 Toyota 4Runner

1 Answer

Need to fix drivers side door , need to remove inside panel on door


Usually a few screws on the handle etc. When they are removed all that is left holding the pannel are pull clips carefully push a flat scredriver between the pannel and the door pry carefull until one or two snap open you should then get your hand behind the pannel then a sharp pull will remove it.

Aug 05, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

1998 Chevy Malibu Window console


you will have to remove the door pannel and free the mechanism from the back side of the door pannel, there will be some clips holding it in.

Jul 17, 2009 | GMC Envoy XL Cars & Trucks

2 Answers

Replacing passenger side mirror


no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.

May 28, 2009 | 2003 Nissan Xterra

1 Answer

Need to replace interior driver side door panel on 2003 jeep wrangler, full size doors. how do i get it off?


to remove the door pannel there is 2 screws and then like everything ells on jeep there are little clips that you need to pull off, try removing the screws and then pulling from the interior pannel

Mar 21, 2009 | 2003 Jeep Wrangler

1 Answer

1999 Rodeo Electric Windows Switch Panel - Drivers Side


gotta remove the door panels there a panel removing tool looks like a snakes tounge but bigger these pop out your door pannel
they take the panel pins out without damageing the door pannel
disconnect electric switches

the electric assembly in side is rivited in so is your going to remove gears you need to drill out revits then work it out of door panel

May 28, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
1998 Ford F150 Regular Cab Logo

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...