Question about Nissan Pathfinder

1 Answer

How do i replace the starter in a 1993 nissan pathfinder, V6, automatic w/4wd

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 337 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Nissan Pathfinder 4wd starts and runs fine but it will not go into gear to drive or reverse,what is the problem?


How To put a Nissan Into 4 Wheel Drive - YouTube

? 2:09
https://www.youtube.com/watch?v=IirIxH0WIVI
Mar 13, 2011 - Uploaded by suzuki230
Just a quick How To, on putting your Nissan into 4 wheel drive. ... to warn the newbies not to drive on hard surface while in 4WDthis can ... If you're having difficulty engaging the 4wd low gear, you can steer ... Hey man i have a 1991 nissan pathfinder SE im going to install a ... How fast can you go on 4L?.

Nissan Pathfinder Questions - automatic will not go into any ...

www.cargurus.com > Questions > Nissan > Pathfinder

CarGurusautomatic will not go into any gear - was driving and parked. now it wonit go into gear. ... Asked by avips Apr 14, 2010 at 04:02 PM about the 1993 Nissan Pathfinder. Question type: Maintenance & Repair ... 2002 Nissan Pathfinder LE 4WD.

Automatic Transmission May Not Shift Correctly at High ...

repairpal.com > Problems > Toyota > 4Runner
truck periodically will not shift into drive at initial start-up. Will very often shift ... 1990Toyota 4Runner- Automatic Transmission100,000Visitor. I have very similar ...

10 Most Common Transmission Problems



Jan 01, 2016 | Nissan Cars & Trucks

1 Answer

How to remove a camshaft on a 1993 nissan Pathfinder


http://www.nicoclub.com/FSM/Pathfinder/1994_Pathfinder/em.pdf

tis is for a 1994 but it should work for your 1993 model

has both the 4 cyl and v6

Apr 02, 2015 | 1993 Nissan Pathfinder

1 Answer

93 pathfinder dont know how to hook up the starter


Obtain a Hayne's Repair manual for your make year and model.

May 04, 2012 | Nissan Pathfinder Cars & Trucks

1 Answer

Where is the hookup for the code reader


For 1993 Nissan/Datsun Truck Pathfinder 4WD 3.0L SFI 6cyl the OBD Diagnostic Link Connector is located: Front seating area, driver side, driver side of steering column, under dash, mounted above fuse panel.

Hope this helps (remember to rate this answer).

Feb 05, 2011 | 1993 Nissan Pathfinder

1 Answer

How do i change the starter motor on a 1993 pathfinder


  1. Remove the exhaust manifold heat insulator.
  2. Remove the fuel tube retainer bolt.
  1. On 2wd models with the 6-cylinder engine:
    1. Remove the front right wheel.
    2. Remove the front gravel shield.
    3. Remove the exhaust manifold heat insulator.
    4. Remove the exhaust manifold.
    5. Detach the oil pressure switch connector.
  2. Unfasten the remaining electrical connections at the starter solenoid.
  3. Remove the two nuts holding the starter to the bell housing, then pull the starter toward the front of the vehicle and out.

To install:

  1. Insert the starter into the bell housing, being sure that the starter drive is not jammed against the flywheel.
  2. Tighten the attaching nuts and secure all electrical connections to the starter assembly.
  3. Install all remaining components in reverse order of removal.
  4. Reconnect the battery cables. If applicable, refill and check the oil level. Check the starter assembly for proper operation.



// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 31; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos'; c17hydro_100.gif

Starter removal on 2WD-6-cylinder engine






c17hydro_101.gif

Starter removal on 4WD-6-cylinder engine


On 4wd models with the 6-cylinder engine:

Remove the front gravel shield.

    1. Detach the oil pressure switch connector.
    2. Drain the engine oil and remove the oil filter.

Jan 19, 2011 | 1993 Nissan Pathfinder

1 Answer

Need to replace starter on 1995 v6 pathfinder looks like if oil filter is removed starter will come out from top


If it's 4WD it recommends removing front gravel shield, and connector from oil pressure switch, then drain oil and remove oil filter. Then should come out top.

Nov 06, 2010 | 1995 Nissan Pathfinder

1 Answer

1993 Nissan Pathfinder XE-V6 right-side BRAKE PROBLEMS ????


THE CLICKING NOISE IS THE SHIFTER LOCK RELEASING, NOTHING TO DO WITH BRAKE LITES. CHECK FOR GOOD GROUNDS AT REAR LIGHT SOCKETS.

Jun 17, 2009 | 1993 Nissan Pathfinder

1 Answer

How do I use the 4WD on a 1993 Nissan Pathfinder?


For 4W Hi either be stopped or moving at a slow rate of speed (<20 MPH) and move your 4WD selector to the 4 Wheel Hi position.

For 4W Lo stop and move the selector from 2W Hi to 4W Hi then push down on the selector and move through N into 4W Lo.

Dec 20, 2008 | 1993 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

307 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...