Question about 1998 BMW 8 Series

1 Answer

I need a radio code

I need a code badly for this radio its driving me nuts and no one seems to be able to help.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • BMW Master
  • 5,284 Answers

Gumtree.com

Posted on Jan 24, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello since my battery was of my radio did not work. The official code seems to be wrong! It is the radio type Ford Focus 5000 RDS-


If the original code is wrong, then either the radio was replaced or written down incorrectly. Any Ford dealership should be able to help you with the code problem and shouldn't charge or a small fee.

Aug 21, 2012 | 2000 Ford Focus

1 Answer

Radio in "09 Ranger starting


Those nuts don't need car diagnostics for a radio. Take the car to a dealer recommended radio repair shiop. Potential cracked pc board in radio.

Apr 23, 2011 | Ford Ranger Cars & Trucks

1 Answer

All I need to know is the poper way to start car. press, wait, press hold, press press, No one seems to be able to help me and my wife is driving me nuts. It's her car.


Your driving us nuts

You never said what car you have
or what the issues are

All you need to do is turn the key,
don't even touch the gas pedal

Mar 14, 2011 | Ford Escort Cars & Trucks

1 Answer

High pitch noise when excelarating past 75-80 mph, seems to be coming from where the dash meets the windshield. Becomes louder and more frequent when driving in really winding conditions. it goes away when...


Well how short a drive is it.........to get you to go nuts. Is it a high pitched whine? If so look to your right. Is the wife sitting there? If so. That's the problem. Going 75-80 in a 25mph school zone will cause that. And where is the speed limit 75-80 anyway.


It's the radio, btw, install an inline filter to filter out the alternator noise.

Jan 02, 2010 | 2006 Jeep Grand Cherokee

1 Answer

1999 Venture - Intermittently dash gauges (idiot lights) come on.


CHECK THE ALTERNATOR OUT PUT USING A DIGITAL VOLT METER.IT SHOULD BE 13.5 TO 14.5 VOLTS.IF NOT REMOVE IT HAVE IT CHECKED AT ADVANCE AUTO OR AUTO ZONE.THEY WILL CHECK IT FREE.DUE TO LOCK OUT FEATURES.BESURE TO TURN OFF RADIO.BEFORE REMOVING THE NEGATIVE BATTERY CABLE.SO YOU WONT LOSE RADIO CODE TO PLAY RADIO.

Aug 17, 2009 | 1999 Chevrolet Venture

1 Answer

How to replace thunderbird antenna


please rate service.

Automatic Electric Antenna
Removal
  1. Lower electric antenna (18850) .
  1. Remove rear retaining screws of RH front wheel splash shield for access to antenna lower retaining bolt.
  1. Remove lower retaining bolt.
  1. Remove radio antenna nut (18865) from top of motor tube and remove electric antenna through fender/splash shield access.
  1. Disconnect signal cable and motor wire connector(s).
Installation
  1. To install, reverse Removal procedure.
  1. Tighten top radio antenna nut to 6-8 Nm (54-70 lb-in).
  1. Tighten lower electric antenna retaining bolt to 5.8-7.8 Nm (51-69 lb-in).
  1. Check operation of electric antenna and radio chassis .

    Automatic Electric Antenna


    1faf511.gif

mast
Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly.
Removal
  1. Remove radio antenna nut (18865) and radio antenna stanchion (18919) .

    ssd~us~en~file=l6389b.gif~gen~ref.gif

  1. Loosen retaining nut inside tube using 14 mm (9/16 inch) socket, and slide nut part-way up mast.
  1. Raise antenna to run plastic drive wire at bottom of mast out of motor. Note direction of teeth on plastic drive wire.
  1. Saw off damaged portion of antenna mast. Remove burrs from mast and slide nut and contact tube off stationary tube.
Installation
  1. With the teeth on the plastic drive wire facing toward motor on antenna, push end of plastic drive wire of replacement mast assembly down into tube. Push it around curve at bottom of tube until end enters drive mechanism.
  1. Run motor down while pushing on plastic drive wire until about 305 mm (12 inch) of wire has been drawn into the tube. Stop motor and insert bottom of antenna mast into tube. Lower mast.
  1. Slide contact tube and radio antenna nut down antenna mast. Tighten nut to 0.45 Nm (4 lb-in).

  2. Raise and lower antenna several times to ensure proper operation.
651247a.gif

Jul 09, 2009 | 1995 Ford Thunderbird

1 Answer

My radio needs a code


You need to pull the radio out and take it to Honda. They can get your code off of it.

May 30, 2009 | 2004 Honda Accord

2 Answers

2001 Acura 3.5 RL Radio Problem Stopped Working - Inoperable


need raido code for 01 acura, anyone got it?

Apr 30, 2009 | 2001 Acura 3.5RL

2 Answers

Code for Kia Sportage 2002 radio


radio needs to be removed to access a number on rear of radio
then dealer will give you code with that number.

Aug 20, 2008 | 2002 Kia Sportage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...