- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The steering shaft has splines that allow the steering wheel to be positioned correctly with the front wheels. Try tapping behind the streering wheel with a hammer to loosen so you can pull the steering wheel off. If this does not work then you need a wheel puller to pull the steering wheel off the steering shaft.
Toyota Corolla has been around long enough that many owners find
themselves needing to replace the factory stereo. Installing a new
stereo in the Toyota Corolla gives improved sound and updated
features. Swapping out the stereo in the Toyota Corolla takes basic
tools and less than an hour. This article covers models from 1990 to
the hood and remove the negative battery cable from the terminal.
Apply the parking brake and place the car
> Remove the trim from
around the stereo by prying with your fingers at one corner. Some
early models have two screws at the top of the trim piece to remove
first. Allow the trim to hang on the drivers side of the dash if
it's connected to the cigarette lighter.
> Locate and remove the
four screws holding the stereo in place. Pull the radio out of the
dash and disconnect the wires from the back of the head unit.
> Connect the wiring
harness adaptor to the original harness and let it hang from the
dash. Slide the new stereo into the Toyota radio mounting kit, which
is a thin metal cover and secure it per the manufacturer's
instructions. Most adaptors have screws to hold the stereo in place,
however some have clips, which engage automatically. >Plug the wiring harness
adaptor and antenna wire into the back of the new head unit and push
the entire assembly into the dash. Reconnect the negative battery
cable and turn the radio on.
> Ensure all of the stereo
controls and speakers are working. Secure the radio in the dash with
the original four screws and replace the trim.
what you need is to buy a wiring adapter for your car.it only cost about 15 bucks and plugs right in to your original plugs that were connected to your factory radio.the great thing about this adapter is that you dont hava to cut your original plug off just in case if you ever want to reinstall your original back.also the wires that go to your new headunit are color coded to match the exact colors that you connect to your stereo.you can't mess your connection up because all you have to do is connect each wire to the right color,tape them up,connect your stereo and you have music with all of your speakers working like they should and without any headaches.i hope this info helps.take care and good luck, manny
Sounds like air in the fuel line. Try turning the key ON and pumping the gas pedal (it may take 10-15 times) and then try to start the car. You need to force gas through the fuel lines to dispel the air it was pumping when the car ran out of gas. If it doesn't work the first time, let it rest and repeat by pumping the gas. Best of luck!
Radio Constant 12V+ Wire: Blue/Yellow
Radio Switched 12V+ Wire: Gray
Radio Ground Wire: Brown
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Antenna Trigger Wire: N/A
Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Pink
Left Front Speaker Wire (-): Purple
Right Front Speaker Wire (+): Purple
Right Front Speaker Wire (-): Light Green
Rear Speakers Size: 4′
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Black
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Red
Right Rear Speaker Wire (-): White
youll need ratchet and socket unhook spark plug wire,change plug 1 at a time not to mix wiring up,what could be a great help haynes shop manual for your car,they discribe and lots of things,for about 20 bucks.
1990 Toyota Corolla Car Stereo Radio Wiring Diagram.
Radio Constant 12V+ Wire: Blue/Yellow Radio Switched 12V+ Wire: Gray Radio Ground Wire: Brown Radio Illumination Wire: Green Radio Dimmer Wire: N/A Radio Antenna Trigger Wire: N/A Radio Amp Trigger Wire: N/A Front Speakers Size: 4′ Front Speakers Location: Dash Left Front Speaker Wire (+): Pink Left Front Speaker Wire (-): Purple Right Front Speaker Wire (+): Purple Right Front Speaker Wire (-): Light Green Rear Speakers Size: 4′ Rear Speakers Location: Rear Deck Left Rear Speaker Wire (+): Black Left Rear Speaker Wire (-): Yellow Right Rear Speaker Wire (+): Red Right Rear Speaker Wire (-): White
If Biggy1 has described it right, I think when you remove the WIRE to the spark plug ( not the plug itself ) and oil jumps out, there is a cylindrical seal that needs replacing and one does not need to even remove the cylinder head. I have the same problem with my corolla. On the other hand if Biggy meant when removing the SPARK PLUG oil was on the contacts....