Question about 2007 Saturn Outlook

2 Answers

Change headlight Could you assist me in changing my 2007 Saturn Outlook's right low-beam headlamp? Thank you. Virgil

Posted by on

  • davidweber Jan 03, 2009

    design makes it impossible to find the last clip holding it. did you get a solution yet?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I just got this done. You don't have to do anything under the hood. (i took too much apart. do not do that) remove the four philips screws from the wheel well covering. with the tire turned to the inside you can reach the seal cap at the rear of the head lamp housing. two clips hold the lamp housing into the electrical socket. use your thumb nails to spread the clips and pull the lamp housing out of the electrical socket.

Posted on Jan 03, 2009

  • dewdad Oct 14, 2010

    Reaching throught the wheel well worked like a charm for my 2009 outlook. Thanks for the top.

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem and decided to call Saturn as my car was still under warranty...I would not have thought a lightbulb would have been covered but am told that it is...easy solution.

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the headlamp relay on a 2007 saturn ion


Are both low beams an high beams not working ? What engine does your car have ? Low beam relay only on 2.2 L .
On vehicles with manual headlamps, the LH HDLP and RH HDLP fuse in the fuse block - under hood, supply battery positive voltage to both low beam lamps and high beam lamps at all times. The low beam and high beam circuits continue through the fuse block - under hood, through the body control module (BCM), and to the headlamp switch. The low beam or high beam circuit then, depending on the position of the dimmer switch, continues through the headlamp switch. When the headlamp switch is placed in the ON position, it provides a ground path for the low beam or high beam lamps through G203. The low beam and high beam circuits are monitored by the BCM.
Is there B+ voltage at the headlamp fuse's ? Power runs from fuse through the head lamps to the dimmer switch through the head lamp switch to ground when turned on . If there is B+ voltage at the fuse ,check for voltage at the headlamp switch .
The

Oct 16, 2016 | 2007 Saturn Ion

1 Answer

HOW TO REMOVE A HEADLIGHT FROM A 2007 SATURN OUTLOOK XE


Hi Carol , your going to have to remove the headlamp assembly to replace the bulb !


Remove the headlamp assembly. Refer to Headlamp Replacement.



1



Headlamp Bulb Accessory Covers (Qty: 2)



2



Headlamp Bulb Assembly (High Beam)




Caution: Refer to Halogen Bulb Caution in the Preface section.




Tip

Disconnect the electrical connectors and remove the bulbs.



3



Headlamp Bulb Assembly (Low Beam)


Callout

Component Name

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .




Headlamp Assembly Bolt (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten

6 N?·m (53 lb in)







2





Headlamp Fascia Brace Fender Reinforcement Bolt




Tighten

6 N?·m (53 lb in)







3





Headlamp Cam Adjuster




Procedure

Set the headlamp adjusters at the nominal setting of 6 turns off fully seated.







4





Headlamp Cam Locking Nut







5





Headlamp Assembly




Tip

Disconnect the electrical harness as the headlamp assembly is being removed from the vehicle.

Apr 08, 2015 | 2007 Saturn Outlook XE

2 Answers

How to change a headlight for Saturn outlook for 2007


All Saturn Outlooks require the removal of the headlight assembly to replaced the headlight bulb. Some of them can be replaced without removal, but it requires very small hands and long arms to be able to access the bulb. Saturn had an issue with headlight bulbs on the Outlooks that caused them to burn out early. The fix was to replace the wire harness for the headlamp assemblies. Might want to check with your local Saturn dealer (if they are still open), or the local GM dealer to see about the wire harness issue.

May 25, 2010 | 2007 Saturn Outlook

1 Answer

How do you change the low beam front headlamp for a 2008 Saturn Outlook?


you must remove the front bumper cover in order to remove the headlamp in order to get to the bulb,,,,its a big pain in the arse,,sorry but there is no easy way,,,take it to the dealer,its not worth your hassle,,

Feb 23, 2010 | 2008 Saturn Outlook

3 Answers

2008 Saturn Outlook - How do I replace the low beam headlight? If it is not an easy fix, how much should I expect to pay a mechanic to do it?


This has to be done by pulling the bumper off. More then likely there will be a burned up harness (recurring problem with the 2008 Saturn Outlook) the cost from my Saturn dealership is $185.00 to replace the harness and bulb. Very poor engineering when you have to pay $185.00 to change a bulb.

Dec 16, 2009 | 2008 Saturn Outlook

1 Answer

How do I change my low beam headlight on my 07 saturn aura xr?


To change the low beam, remove the front wheel and plastic inner fender liner. This will give you access to the rear of the headlight and it's plug and play from there.

Dec 16, 2009 | 2007 Saturn Aura XR Sedan

1 Answer

I need to adjust the aim of my headlights. Can


Hello

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Nov 04, 2009 | Saturn Outlook Cars & Trucks

2 Answers

Headlamps need adjustmentthey shine to close to the car even when on high beeam


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Sep 30, 2009 | 2004 Saturn ION

1 Answer

Installation Instructions for the Headlight Buld for 2008 Outlook


It is real hard to replace and some time the wiring harness inside of headlamp if burned if vehicle is still under 36000 miles take it to dealer to have repaired

Apr 01, 2009 | 2008 Saturn Outlook

1 Answer

Change low beam headlight


turn your wheels all the way to the right ot left depending which side you are changing out. take a phillips head screwdriver and take off plastic wheel well cover then you will be able to reach up inside and change out bulb.

Oct 10, 2008 | 2008 Saturn Outlook

Not finding what you are looking for?
2007 Saturn Outlook Logo

3,360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...