Four wheel drive wont engage
If you have push button 4-Wheel Drive, it is recommended that you use it every once in a while, in order to keep gunk, rust, and corrosion to build up on moving parts. The mostly likeley (though not definite) reason would be that you let the 4-wheel drive unused for so long that corrosion has built up on the parts and the actuator that engages the 4-Wheel Drive doesn't have the power to engage it past the corrosion.
You'll need to take it in to be cleaned, or to have parts replaced. In the future, every month or so, engage 4-Wheel Drive and drive around in some mud, grass, sand, or any other loose ground for a bit, just to keep the parts moving and clean.
The service Four wheel drive light is to alert the operator the system is not being read properly by the ECU.
If the ECU loses contact with or position of the Transfer case actuator motor the service light will come on. Same thing goes for the front diff actuator.
So it may be a bad switch, sensor, or an actual problem in the 4WD linkage. This is not a Oil Change light that you can ignore a few extra weeks - it indicates a problem that should be taken care of ASAP to avoid costlier problems down the road.
Thanks for using FixYa - a FixYa rating is appreciated!!
Feb 21, 2009 |
2004 Chevrolet Suburban