Question about 1995 Acura Integra Coupe

1 Answer

85 el camino auto trans indicator on column (tilt) is misaligned.  "park" is neutral, "neutral" is drive etc. - can this be calibrated back to accurate?      Ken

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Look on the bottom of the column there should be a small clip you will only see the outside of this clip but on the inside there is a cable that moves try adjustig this clip by sliding it

Posted on Dec 19, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does my 1985 el camino have to have check engine light


In regions where smog checks are required to register your vehicle, YES. In regions where smog checks are not required, you should fix the CHECK ENGINE light anyway, as it is an important warning of engine issues.

May 14, 2015 | 1985 Chevrolet El Camino

1 Answer

1985 el Camino 305 Rough Idle and Automatic Choke out


If electric choke not working and blade on carb is not fully opened, that would cause your issue...check for power at choke stat, if not, check fuse

Mar 25, 2014 | 1985 Chevrolet El Camino

1 Answer

Gear position indicator modulator


I have a 1999 Sienna toyota but my flickering light when car on..

Jan 05, 2014 | 2002 Chevrolet Silverado 1500

1 Answer

I have 85 el camino with a th350 which was recently rebuilt. The shop after numerous attemps could not adjust the linkage correctly. I only had park,neutral, reverse and drive. I could not get it into...


The linkage ratio is off. This is the measurement from the center of the shifter shaft (the shaft that comes out ot the transmission) to the center of where the linkage cable/rod attaches to the arm that bolts to the shifter shaft. This distance needs to be shortened. THis will allow mre movement to give you 3nd and low.

May 02, 2017 | 1985 Chevrolet El Camino

1 Answer

How to remove ignition switch from 1977 chev el camini tilt column


Pull the steering wheel, get the push down tool to push down the lock plate to remove the plate, then pull the turn signal cam theres a screw on the right hand side of the shaft that holds the cylinder in.

Jul 23, 2010 | 1982 Chevrolet El Camino

2 Answers

Shift indicator cable


I just fix the same problem on my 83 el camino today. The indicator is just a plastic pin connected to a wire and uses a small spring to return to park. I took out the dash board pannel in front of the gauges. There are two 7mm screws under the indicator, remove those. Drop indicator down, check to see if the plastic hoop the wire connects to has broken off. If so I connected my wire to the hook on the return spring, every thing works fine now. I had to fix this to get it threw Maryland inspection.

May 31, 2009 | 1987 Dodge Caravan

1 Answer

Cannot locate the horn relay on my 85 El Camino. Some say it should be under dash on passenger side, some say driver side. Any ideas?


Found these documents for you.

85 ElCamino1
85 ElCamino2

In fact there IS a horn relay. I have circled the circuit you are looking for in red.
I would search under the dash on driver's side.

Find the Ignition Harness and follow the wires back to the firewall.

Please download and save these pics to your hard drive - as they are stored on my personal FTP storage, and i will remove them in 24 hours.

Thanks for Using FixYa - a FixYa rating is appreciated for answering your FREE question.


Mar 26, 2009 | 1985 Chevrolet El Camino

1 Answer

85 El camino Gages work then dont


you probobly have a wire shorting out some place ...

Mar 13, 2009 | 1984 Chevrolet El Camino

1 Answer

Trans. problem


3speed or 4 speed? does it slip or just not shift. Might be old seals or a bad governor. Try using lubegard trans additive. Try that for a week if it doesn't work, replace the governor valve.

Feb 27, 2009 | 1986 Chevrolet El Camino

1 Answer

Need to open up the steering column on 1983 El Camino for igniti


Saw, It sounds like the accuator rod from the ignition lock cylinder to the ignition switch is broken or disconnected.
If you look near the base of the steering column you wll see the ignition switch mounted to the steering column. As you turn the key you should see the rod move up and down, if not, you will have to disassemble to figure out why.
Good luck, let me know what you find.
Regards,

Feb 24, 2009 | 1983 Chevrolet El Camino

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...