Security alarm i need help trying to get my 1995 jeep grand cherokee laredo started. i cannot seem to find the wireless remote starter so can you tell me how i can possibly start it and keep it from stalling on me?

The size of the bolts that go on the starter of a 1995 Jeep Grand Cherokee Laredo will depend on the model of starter you are using. In general, most starters use bolts that are M6, M8, or M10 in size.
To determine the size of the bolts you need, you will need to refer to the manufacturer's specifications for your particular starter. You can usually find this information in the documentation that came with the starter, or by contacting the manufacturer.
It is also important to note that the starter bolts may not be the same size as the original bolts that came with the vehicle. If you are replacing the starter, make sure to use the correct size bolts as specified by the manufacturer of the starter. Using the wrong size bolts could result in damage to the starter or the vehicle.

The 1995 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

first use your remote, lock-unlock-lock-unlock 5 times. use the key to unlock the door. lock with remote. If this fails, disconnect battery for 5 min. reconnect, should reset control module..

go to a stereo shop that does remote starts and talk to them if there any good they will know

the alarm seems to be activated. press the button and turn the key.

remove the fuse

i have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

When you put the jumper cables on, put the key in the drivers door lock and unlock the door to deactivate the factory alarm.

There are switches on the door lock cylinders that are supposed to shut the alarm off when you use the key,but they go bad allot. you could try unlocking the passenger door first, since that one usually gets less use and is less likely to go bad. Otherwise you can disconnect the alarm module, it is located behind the glove box.

go to the hatchback and turn the key to the right