Question about 1993 Chevrolet S-10 Blazer

1 Answer

Chev Blazer Saw your response on 4wd today. I have a '93 blazer. Occasionally (usually after parking and putting in reverse) the 4wd kicks out and i hear a higher pitch grinding noise as if something is trying to mesh. Vehicle doesn't move at all until I click back in to 2wd. Doesn't happen very often but very annoying when it does. Happens occasional in drive also. Any suggestions??

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 106 Answers

Sounds like your transfer is going bad... get rid of it quick or it's going to cost you a lot of headaches and money
good-luck ray

Posted on Jan 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1995 chev blazer wont go into reverse

I think you will start your new relationship with the
S10, by doing a complete trans rebuild

See if the seller will share some history on veh

May 24, 2012 | 1995 Chevrolet Blazer

1 Answer

Hi i have a 2000 Chev Blazer, the service 4WD light appears now and then , we never use 4WD so was not worried about it until today i tryed to put into 4WD and it would not work the lights on the buttons...

one of my vehicles is actually a 2000 blazer and i had that same problem believe it or not. you should check all the connections to the brain of the 4wd. take off the passenger side right side kick panel. the kick pannel is that piece on the side right there next to the door. take that off and you will see a grey box. pull the wires out and look at the ends. i cleaned mine out with a q tip because there was crud in one of them which screws things up. if that doesnt fix it you may need a new one. they can be really expensive from a dealer so i went to a wrecking yard and pulled one out of another blazer and it only cost $20. it works fine now :) i hope that helps.

Jan 06, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

How to shift in and out of 4 wheel drive with a push button system on a 93 s10 blazer

this sytem is shift on the fly!! you can engage and disengage from 2wd to 4wd at speeds up to 45-50mph, 4wd lo you need to be a complete stop some cars need to be in neutral with parking brake on and some need to be in gear there all different, consult your owner manual for correct shifting pattern to 4wd lo range

Sep 26, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

Need to change alternator on 1993 chev 4wd 4 door blazer engine 4.3 liter

ok no problem. first off unhook the possitive on the battery. then find the belt tensioner. there should be a sqaure hole in it for a rachet to go into. use the rachet(usually the 3/8's drive)to move the tensioner to where you can slip the belt off the alternator. then remove the nut off the back of the alternator to take the hot wire off. Then there is a plug on the back of the alternator. unplug it. next take the three bolts out of it and remove it. then put the new one on and repeat steps in reverse. If you have problems with how the belt goes back on then look around the engine bay. usually there will be a sticker with how it goes.

Jul 29, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

1995 Chevy S10 Blazer will not go into park.

theres a shift cable if its floor model,linkage for column model.

Apr 25, 2009 | 1995 Chevrolet Blazer

1 Answer

96 blazer

With the selector in 2WD, attempt to slowly move the car forward (drive)and backward (reverse) in an area of 15 or 20 feet. That should release the 4WD gearing engagement.

Good luck

Mar 27, 2009 | 1999 Chevrolet Blazer

1 Answer

1998 Chev Blazer,4WD light comes on Code U1064.

check control box on pass. side,under kick panel,check elect.connector for corrosion,usual suspect! on 96 and later blazers with elect,shift,hope it helped!

Mar 24, 2009 | 1999 Chevrolet Blazer

1 Answer

Nuetrual 4wd option

Push button 4WD has no neutral option. It is either in 2wd, 4hi, or 4low.

Dec 13, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides