- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.fixya.com/cars/t6229586-hold_warning_light_means Sep 30, 2010 - Mitsubishi 1998 Montero Sport question. ... Theres a red light on that looks like the check engine light but it says hold in it, what does it mean. Jan 28, 2011 ' 2001 Kia ... Which O2 sensors relate to error codes PO130 and.
OBD=11 code p0171 refers to system to lean---causes ---intake/ exhaust leak---air system---MAF/VAF sensor---fuel pressure/ pump---injectors HO2s code po105 refers to manifold absolute pressure (MAP) sensor/bar ometric sensor and circuit malfunction causes---wiring---MAP sensor ECM code p0760 refers to shift solenoid--circuit malfunction causes--shift solenoid---ECM?TCM code po770 again refers to shift solenoid. code p0171 again refers to shift solenoid ---performance or stuck off. code po130 refers to heated oxygen sensor HOS2 1 bank 1-circuit and have the rest checked .malfunction -- causes---heating inoperative---poor connection---wiring--- HO2S. So replace the shift solenoid and oxygen sensor
I guess you have no knowledge what so ever, about
OBD vehicles systems or check lights
They have been on all vehicles for 31 years
Check for codes -- in a couple of days
Diagnose the system with the malfunction --- couple more days
Make repair or stop using the vehicle --one week -- start to finish,once
you get any type of dash light on
Given that most of the trouble codes are for the O2 sensor, I think I would change it. The multiple misfires could be because of improper fuel/air mixture caused by a bad sensor. Disconnect the negative(-) battery terminal then change the sensor. Disconnecting the negative(-) should reset the computer and allow the fuel/air mixture to return to default allowing the engine to start.
P0130 - O2 Sensor Circuit Malfunction (Bank 1 Sensor 1)
P0134 - O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)
P0135 - O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)
P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)
P0300 - Random/Multiple Cylinder Misfire Detected
if u have one oxygen sensor then u need to take a deep look at the bottom of ur car it will be somewhere at the Exhaust pipe
if u have a catalytic converter then u will have two oxygen sensors one before the catalytic converter & the other will be after the catalytic converter.
Note: the catalytic converter is located at after a little bit of beginning in Exhaust pipe.