Question about 1994 Chrysler Concorde

1 Answer

Shut down 94 concorde runs when cold when it warms up it shuts down and while u r driving it

Posted by on

  • fireace Jan 03, 2009

    i have the same problem. when you go around a corner slow or slow down to make a turn the car stalls. this does not occur when the car is cold. i did replace the air intake senso in the auto body which helped but only for a few days then back to the same problem



    Gene

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

This happened to me on my 94 concord. I had to replace the ign. switch.

Posted on Dec 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my 94 accord 4 cyl start when its warm out?


A common problem with no-start Honda cars is the fuel pump relay under the dash.
I would check that first. Could also be a faulty coil.

Sep 10, 2012 | Honda Accord Cars & Trucks

1 Answer

Stopped running while driving


i would first check the crank position sensor,i have seen this many times before.

Feb 16, 2010 | 1997 Chrysler Concorde

2 Answers

Hi, my 94 lincoln towncar is giving me problem?


This problem sounds like the Idle Air Control is sticking when cold. At the back of the intake manifold, at the base of the elbow where the rubbber air plenum clamps on, is where the IAC is located. It has an electrical connection with a red and a white/light blue wire. Replacement is recommended, but sometimes the sticking can be resolved by removing and cleaning.

Feb 09, 2010 | 1994 Lincoln Town Car

1 Answer

Heater on 1995 Chrysler Concorde stopped heating. Replaced water pump and thermostat. Blows semi warm air out of one dash vent and pure cold out of other dash vent. Does anyone know codes to reset?


there are no reset codes, did you bleed the air out of the cooling system? if not do this procedure, if that doeasn't fix it u have a failed air temperasture control blend door motor actuator.
The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml ,

Jan 11, 2010 | 1995 Chrysler Concorde

1 Answer

94 Chrysler Concorde Tranny Problems


Have your transmission oil filter changed;
it is located under the transmission pan
The oil is what makes the transmission shift
When you shut off the engine it stops the transmission pump then when you start up again the transmission shifts until the filter clogs again

May 28, 2009 | 1994 Chrysler Concorde

1 Answer

94 olds hard starts when warm, starts when cold and runs rich


If you can get a fuel pressure gauge, check and see if the pressure is 16 to 24 lbs after the engine has warmed up.
I would connect the pressure gauge when the engine is cold, make sure it does not leak or touch anything hot, place the gauge between the hood and the windshield and drive the vehicle until it is at the temperature you feel it "starts hard". Shut the engine off and try to repeat the no start or hard start and make sure the pressure is correct.
Also, when you shut the engine off, watch the pressure and make sure it holds and does not drop to (0 LBS) of pressure.
One last question, has the fuel filter been changed in the past 30K.
Let me know.
Regards,

May 08, 2009 | 1994 Oldsmobile Bravada

1 Answer

1989sunbird starts cold then shuts down electricly when warmed up


i would recheck the ignition module, sound bad to me. make sure that you test the module when hot

Apr 20, 2009 | 1989 Pontiac Sunbird

1 Answer

Engine Quits


sounds like a tipical crankshaft position sensor will fix your car

Sep 26, 2008 | 1993 Chrysler Concorde

Not finding what you are looking for?
1994 Chrysler Concorde Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...