Question about 1996 Geo Prizm

1 Answer

95 geo Flashers

95 geo prizm My blinkersand hazards stoped working. Fuses are good what do i do now?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

It's probably a blinker relay. If you can find one, it'll probably be remanufactured or from a junkyard. Take it to the mechanic.

Posted on Dec 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car wont start flashers wont stop flashing. 97 GEO


double anon post.
backup one post and read.
left or right lights? if both that is HAZARDS stuck on.
cycle the hazard switch , bingo?????
there are 2 fuse, Turn, and HAZ, one must kill the blinking
which one? PULLED.?
you double post and ANON to boot., so here i ask again,.
it dont crank
or cranks ok fast but will not start.????




3ac9d2c7-ec3e-476d-91d3-96f244434387.jpg

Sep 23, 2014 | 1997 Geo Prizm

1 Answer

Turn signal & flashers stopped working on '95 geo tracker 2wd, 5 speed.


old post 95 tracker.
ALL four corners dead and dash (warn lamp dead) in cluster
do you hear i flash, click click????
first is fuses, but there are 2 .
http://www.fixkick.com/power-elect/95%20electrics/all-lamps95b.pdf


page 2 see that.
are the 2 blink/has fuses good. test good not just LOOK good
after all if a feed is shorted you will blow both. (tested)

the blinker module ,usually dont fail
its electronic and robust.
fuses good, then
the black wire ground cut or rusty a body
G200 it uses, and if bad usually kills the engine.
yellow-white must be 12vdc blinks on. key on
switch is bad. i bet this is ok
the relay green is OUTPUT
if the blinker has power it clicks
if it green wire flashes with test lamp the blinker module is good
if the output of the blinker switch is dead L and right
the switch is bad.
assumes both left and right sides not shorted. to ground.

Feb 16, 2014 | 1995 Geo Tracker

1 Answer

My turn signals stoped working on my 95 chevy Tahoe, The hazard lights work and when I turn the alarm off or on they flash. I've had the flashers checked, the relay checked, and the switch has been...


Try checking fuses under the hood, and under the dash,
there are fuses in both locations, both on drivers side of vehicle.
I hope this helps you.

Sep 11, 2013 | 1999 Chevrolet Tahoe

1 Answer

My interior lights dim when i turn my headlights on on my 95 Geo Prism.


Did you check ground strap between Eng. block and ext. fire wall ?

Mar 03, 2013 | 1995 Geo Prizm

1 Answer

Have 95 geo prizm with no fuel pump relays and fuses are good. when i jump the relay i can hear the pump work.. is there any other sensors that would cause the pump not to work


The oil pressure sending unit will stop the pump from running. This cuts the car off if it senses no oil pressure. Same sensor that gives you the pressure reading or the dummy light.

Mar 17, 2011 | 1995 Geo Prizm

1 Answer

95 suburban. turn signals not working at all. flashers and all other lights work fine. flasher unit good. fuses and bulbs good. any idea? thanks


it could be a short if you have trailer wiring, try unpluging the wiring and see if that works, be sure you looked at the right flasher the hazards and flasher have diffrent flasher units. its possible to have a bad turn signal cam, or a malfunction in your hazard switch.

Aug 28, 2010 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

Turn signal lights and hazard on my 95 geo prizm don't work


look for ur fuse box the fuses are in therehave manual info should tell you where fuse is

Feb 07, 2010 | 1995 Geo Prizm

1 Answer

1993 Geo Prizm Lsi Harmonic Balancer


Yes a harmanic balancer from tha corolla is the same thing. I had to do the same thing with my 95 geo. It works out to be a lot cheaper buying for a toyota than a geo.

Jan 11, 2009 | 1995 Geo Prizm

2 Answers

Turn signal


The wire under the hazard button has probably come loose. Most GMC vehicles this year range were made with a closed circuit wiring between the flashers, hazard lights, and rear defrost. Over time the wiring under the hazard button has been known to loosen. This causes the whole system to lose function. If pop out the hazard button on you center console you should be able to tighten that wire back on and the system should work again.
The same thing happened to me when I put in a new radio. I bumped the wires off and my blinkers, rear defrost, and hazard lights went out. I replaced the fuses and the flasher relay but nothing. Then I asked a mechanic and he told me what I just told you.
Hope it helps!

Nov 04, 2008 | 1997 Geo Prizm

1 Answer

Electrical problem?


If you haven't fixed it yet...
check your fuses. when lots of things suddenly stop working at once usually means you have a blown fuse.

May 25, 2008 | 1997 Geo Prizm

Not finding what you are looking for?
1996 Geo Prizm Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...