Question about 2003 Toyota RAV4

1 Answer

My rav4 d4d 2.0L (52) wont start first time and is taking longer and longer. I want to bleed the system but dont know how to??

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 449 Answers

You need to check for gas and spark, disconnect one of the spark plug wire and put it close to the engine block and have someone crank the car you should see spark. the way you check the fuel pump turn the ignition on engine off you should here your fuel pump turn on or you should here a buzz.

Posted on Dec 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

04 rav4 d4d cuts out and usualy starts again

This website has the largest collection of repair, service, parts manuals of any vehicle on earth.
Best website I came across for manuals.. Very helpful website

Mar 08, 2018 | 2004 Toyota RAV4

1 Answer

My toyota Rav4 D4D crank but won't start.

If there is no supply from the ignition switch, it will not start and the ODB will not connect.

Oct 06, 2017 | Toyota Cars & Trucks

1 Answer

2009 RAV4 2.2 D4D AWD wiring diagram

The wiring diagrams of this car are broken down into sections of the cars electric and electronic systems. So you will need a factory repair manual to get what you need. You can find used factory manuals on eBay most times for a fraction of the new books.

Jun 16, 2016 | Toyota RAV4 Cars & Trucks

1 Answer

Can anyone please tell me where the cam sensor and crankshaft sensor are located on a 2002 RAV4 2.0 D4D...116BHP Problem is wont start when engine is hot.

this a diesel. (our is 2.4Lgas(petrol)
cold starts fine,runs perfect cold RIGHT?
common rail system.

the PCM will tell you when those are bad, cranking for 5sec or running.
does your run,. ? if yes for get them. and scan engine PCM.
some sensor takes major work to reach.

get the FSM on that car. y
so get the FSM for your car, your engine and your country
The DI chapter covers this. read that yet? diagnosis?
did you use the scan tool an see what up's up or not ?

your engine really is.
1CD-FTV I4 (diesel)
that is the correct name, so study only that)

no start hot.
its too much fuel or tool little?
to little?
did you try test fuel to see if loss of fuel is the problem?
on diesel it's poor compression
or lost fuel , hot starts.
easy huh , no spark to check , there is no spark
some diesels have 1 sensor for injector timing.
if flooding , you get black smoke out the tail pipe, so id suspect
you'd have noticed that and did not see it.
test fuel, tests.
if this fails, a full hot compression test. its not the cam belt slippped
if runs ok cold,

i bet the injectors are shut down
the PCM tell you why, so let it.
SCAN it. after 5 seconds cranked.
almost all PCM report 1 bad pulse of 10 in all speed sensors.
(CKP or CMP )

Feb 24, 2014 | 2002 Toyota RAV4

1 Answer

Changed the fuel filter on my d4d fortuner and now have aie in fuel sysytem. wont start . howdo i bleed it?

Something else is the problem because it is impossible to get air in the fuel system and have it not start. Look to see what you might have knocked off or broke while changing the filter.

Dec 30, 2013 | Toyota Pickup Cars & Trucks

1 Answer

Head toque settings

double posted, back one. it 2.4 L right? not 2.2?
d4d 2.2
read the TSB on this engine and recalls>? for head gasket ?
best is not to guess. do it right. an use the sequence chart.

most HG fail soon after for not doing the 3 tests.
warp head, warp deck, and surface conditions.
better the FSM and all TSB on head.
here is one on site spec. for both motors.
2AZ-FE/D and/or 2AZ-FE/E Step 1: 52 ft. lbs. Step 2: plus 90 degrees my wild guess INSTALL and not removal? unsaid.
front is left here, cam cog side left

F 8,6,1,2,9

F= front or #1 cylinder end.

take down is different order. (its aluminum, nothing trivial)

Dec 14, 2013 | 2008 Toyota RAV4

2 Answers

Toyota rav4 2.0 d4d, hesitates on acceleration

Look at this thread -seems to be a cure for this problem.

Aug 01, 2010 | 2004 Toyota RAV4

1 Answer

The alarm on my 2003 rav4 d4d keeps going off. How can I reset the alarm system?

Do you have a fob?

1. get in the car
2. shut the door
3. place the key in the ignition
4. lock the doors, manually
5. turn the ignition to on then this seven times
6. unlock the doors and try your remote

The above should program your fob into the car's memory.

Jul 22, 2010 | 2008 Toyota RAV4

1 Answer

Rav4 2003 D4D clutch bite is really low down can it be adjusted?

adjustment that does not bring it up where clucht already reached a time when you can not get the change and have

Jan 12, 2010 | 2003 Toyota RAV4

Not finding what you are looking for?
2003 Toyota RAV4 Logo

Related Topics:

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides