Question about 1997 Toyota Camry

1 Answer

Altenator bearings I need to replace my altenators bearings.It is a bosch.I have done a lukas altenator before but never a bosch.Can you help me on how to do it.

Posted by on

  • jac wilson May 11, 2010

    are you sure its a bosch? it came with a nippon denso.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 21,949 Answers

Just fit an exchange unit more profit

Posted on Dec 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery light comes on and off and computer says service charging system and battery not charging sometimes when I first start the engine its fine but after awhile battery light comes on and battery not...


what you need to do is check the altenator for voltage it should be between 13 and 15 volts this is easily done with a standard volt meter check it at the altenator witch is located right on top of the engine on the back of the altenator there is a thick red wire that is where you want to put the positive and just put the black wire of the volt meter on the case of the altenator and check the reading it sounds like the altenator is bad there is also a fuse you should check your owners manual for location of the fuse also have your battary checked this should help ant questions just ask me

Jan 23, 2014 | Cars & Trucks

1 Answer

Replace alternator 2008 aveo


disconnect negative battery cable. Then remove rubber boot on altenator. Remove nut and cable attached. Unplug and remove wire harness also attached to altenator.
Loosen and remove both bolts holding on altenator.
Remove altenator.
Reverse process to reinstall. Pry on belt tensioner with pry bar and socket to loosen belt and place on altenator pulley after it is installed.
Last reattach battery cable and start vehicle.

Jun 04, 2012 | 2008 Chevrolet Aveo

1 Answer

How to remove altenator from a 96 monte carlo 3.4 litre over head cam engine


  1. unhook battery
  2. take belt off - has a tensioner pull up on to release belt
  3. unhook wires from altenator-mark the wires so remember where they go
  4. take out bolt's that hold altenator on
  5. remove altenator -replace in reverse order

Nov 11, 2010 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Install a altenator for a 2006 jeep commander


I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

May 20, 2010 | 2006 Jeep Commander

1 Answer

I just bought a 93 camara z28 was week and its jus been problems. there is a weird whining noise coming from one of the altenator pulleys. a buddy said the bearing is shot but the worst part is i was...


If it's coming from the altenator it's most likelly the rear bearing. The bearing is pressed in the case and it gets very hot from the friction of the brushes. If you determine this is the problem I reccomend replacing the entire altenator, the bearing and labor to install it will be really close to a new one and you get a warranty depending on where you buy it. If the voltagfe is spiking in the altenator it could be affecting the cruise control, Fix the altenator first and than tackle the cruise if it's still inop.

Aug 24, 2009 | 1993 GMC Sierra

1 Answer

Ford escort lx fuse problem


you may need a new battery now that your altenator went, try jumping your car dose this help ?
with wireing problems like this you may need to find a trust auto shop.

May 29, 2009 | 1993 Ford Escort 4 Door

1 Answer

I have never done this before, changed out an alternator on a 2001 ford focus


1. Disconnect the battery first.

2. Remove all the connectors on the back of the altenator.
3. Remove the screws holding the wires to the altenator.
4. remove the bolts connecting the altenator to the engien block.

Installation in reverse order.

hope this helps

May 24, 2009 | 2001 Ford Focus

1 Answer

1994 geo metro


It's actually super easy.
All you need is your year and make alternator belt and a wrench.
Take off the existing altenator, take off the old belt.
Once the altenator is off you'll be able to look further down below where the altenator was. You'll see a metal wheel that's a little bigger than the one on the altenator. This is where the new belt needs to wrap around.
I found it alot easier to wrap the belts around the two wheels before putting the altenator back on the engine.
Make sure that all bolts and seals are sound. (that's the last thing you need falling off in the middle of nowhere!)
Hope it helped!

Aug 29, 2008 | 1994 Geo Metro

2 Answers

4.2L 2006 Trailblazer


you will have disconect the neg.-BAT TERMINAL then loosen alt. adjusting bolt,remove alt. belt( or remove serpentine belt if so exist) then remove the two existing bolt at the bottom of the alt.then remove altenator.ree-install in reverse direction.

Jul 19, 2008 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
1997 Toyota Camry Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...