Question about 2001 Ford Escape

1 Answer

Looking for cylinder diagram/location on 2001 Ford Escape 6 cyl

Engine is transverse mounted and need to know cylinder locations in order to troubleshoot occasional misfire code. 2001 Ford Escape 6 cylinder

Posted by on

  • Anonymous Mar 23, 2009

    looking for cylinder diagram/location on 2001 Ford Escape 6 cyl

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,376 Answers

Here's the scoop. There is a TSB that addresses this issue.
First, replace the spark plugs.
Next, replace all 6 COPS, coil on plug. You have to because they feed back into the PCM, Powertrain Control Module and blow the drivers. Then you need to replace the PCM.

This was for 2004-06, but it might apply to yours if it's a 3.0L.
buy at tascafordparts.com.

Misfire DTC codes identify which cylinder is misfiring.

Misfire Detection Monitor The Misfire Detection Monitor is an on-board strategy designed to monitor engine misfire and identify the specific cylinder in which the misfire has occurred. Misfire is defined as lack of combustion in a cylinder due to absence of spark, poor fuel metering, poor compression, or any other cause. The Misfire Detection Monitor will be enabled only when certain base engine conditions are first satisfied. Input from the ECT or CHT, MAF and CKP sensors is required to enable the monitor. The Misfire Detection Monitor is also performed during on demand self-test.

  1. The PCM synchronized ignition spark is based on information received from the CKP sensor. The CKP signal generated is also the main input used in determining cylinder misfire.
  1. The input signal generated by the CKP sensor is derived by sensing the passage of teeth from the crankshaft position wheel mounted on the end of the crankshaft.
  1. The input signal to the PCM is then used to calculate the time between CKP edges and also crankshaft rotational velocity and acceleration. By comparing the accelerations of each cylinder event, the power loss of each cylinder is determined. When the power loss of a particular cylinder is sufficiently less than a calibrated value and other criteria is met, then the suspect cylinder is determined to have misfired.
  1. Misfire type A:

    Upon detection of a Misfire type A (200 revolutions) which would cause catalyst damage, the MIL will blink once per second during the actual misfire, and a DTC will be stored.

    Misfire type B:

    Upon detection of a Misfire type B (1000 revolutions) which will exceed the emissions threshold or cause a vehicle to fail an inspection and maintenance tailpipe emissions test, the MIL will illuminate and a DTC will be stored.

    The DTC associated with multiple cylinder misfire for a Type A or Type B misfire is DTC P0300.

    The DTCs associated with an individual cylinder misfire for a Type A or Type B misfire are DTCs P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0309 and P0310.

Posted on Aug 07, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 102 Answers

SOURCE: need a diagram pitcure of firing order for a 2001 Ford Escape

you didn't say which engine so here it is for both
2001 Ford Escape 2WD
2.0 liter DOHC L4 VIN "B" 92714651.gif
2001 Ford Escape 2WD
3.0 liter V-6 VIN "1" 92725094.gif

Posted on Jul 19, 2009

ZJLimited
  • 17970 Answers

SOURCE: firing order diagram ford escape

2001 Ford Escape 3.0 liter V-6 VIN "1"

zjlimited_42.gif

I hope this helps (remember to rate this answer).

Posted on Nov 29, 2010

ZJLimited
  • 17970 Answers

SOURCE: Engine misfire 2004 ford escape v6 3.0 ltr, need

2004 Ford Escape 3.0 liter V-6 VIN "1"

2b4e09d.gif


The next, I "bid" it. Good luck.

Posted on Oct 18, 2010

  • 1757 Answers

SOURCE: I need a diagram of the firing order 2003 Mazda

For the 2003 Mazda MPV 3.0L V6:

Firing Order:
1-4-2-5-3-6

Cylinders:
........(back).......
|...1....2....3...|
........................
|...4....5....6...|
.......(front)

Let me know if this helped.....

Posted on May 06, 2010

Zeevert
  • 373 Answers

SOURCE: ford escape 2002 firing order

Go to:
http://autorepair.about.com/library/firing_orders/bl-ford-firing-02.htm
for a nice picture of V6 or L4 firing order.

Posted on Oct 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 malibu 3100 engine i need number 1 thru 6 cylinders


The engine is mounted transversely (sideways)-the front of the engine is on the passenger side where the serpentine belt runs. On the backside bank, bank one, closest to the firewall, are cylinders 1-3-5, from front of engine to rear. So number one cylinder is on the back bank, and nearest to the passenger side of the car (bank simply refers to which side of the engine on a v6 or v8, bank one or bank two. Bank one is always the side where the #1 cylinder is located, and bank two is the opposite side.) On the front bank or radiator side, bank two, the cylinders are 2-4-6, front to back of engine.

The firing order is 1-2-3-4-5-6, easy to remember.

Dec 15, 2015 | Cars & Trucks

2 Answers

#6 cylinder 2001 escape


the cylinders in the back ( closest to the firewall ) from left to right 1-2-3
in the front ( closest to the radiator ) from left to right 4-5-6. front far right cyl.

Apr 14, 2013 | 2001 Ford Escape

1 Answer

WHAT IS THE FIRING ORDER FOR A FORD FREESTAR 4.2l V6?


The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 )

The engine cylinders are 1 , 2 , 3 from front to rear on the passenger side of the engine and 4 , 5 , 6 from front to rear on the drivers side of the engine

The coil pack towers are numbered 1 , 2 , 3 from front to rear in the row nearest the passenger side and 5 , 6 , 4 from front to rear in the row nearest the drivers side


hope this clarifies the situation for you



Sep 06, 2012 | 2004 Ford Freestar

1 Answer

I need a diagram of 03 ford expedition 5.4 trition firing order... I know the order is 1-3-7-2-6-5-4-8. I need to see which order they are located on the motor.


on a ford the #1 cyl is on the frt pass side of the engine.the cylinders on that side, from front to rear are 1,2,3,4 and on the driver side is from front to rear are 5,6,7,8 .the rear cylinders are the most fun to get to! good luck.

Oct 02, 2011 | 2003 Ford Expedition

2 Answers

Where is the number 4 coil in a 2003 Ford Escape? Is it near the window or more towards the front of the car? Thank you.


Hello ctyloma,

Below is a diagram of the cylinder locations.

netvan_247.png

I hope this helps.

Regards,

Jerry

Sep 24, 2011 | 2003 Ford Escape

1 Answer

I have a 2001 ford escape xlt 4 wheel drive. i had a diagnostic test done & it said it detected a misfire in cylinder 3. i am a do it yourselfer and am going to change all 6 spark plugs but the problem...


I am assuming that you have a V6 Engine because 1, 3 and 5 would be on the other side of 2, 4 and 6. A Striaght in line engine would have them all in a row.

But another way to locate your spark plugs would be to find your Spark plug wires and follow them to the spark plug.

Good Luck

Jun 22, 2011 | 2001 Ford Escape

2 Answers

I need a diagram for the spark plug wiring on a 1980 F100 6 cyl


Hello kat801931,

The firing order is:

1 5 3 6 2 4

Below is a picture of the cylinder order and the distributor. Number 1 cylinder is at the "white" location on the distributor. Good luck.

netvan_53.png

Regards,
netvan

Apr 02, 2011 | Ford F-100 Cars & Trucks

2 Answers

02' Ford escape 6 cylinder: I have coils miss-firing, When it idles, it occasionally rattles and idles funny. But now the engine light is on and the codes say: 4 and 5 cylinder miss-fire. You can't run...


Although you say you have coils misfiring, it sounds like you are not sure.

Trade the coils on cylinder 4 and 5 with coils on 2 and 3. Erase the codes and try to run the engine again. If the misfire code comes up on 2 and 3 this time, the coils are definitely the problem. If the code comes up for 4 and 5 again, there is something else besides the coils that is causing the misfire on those two cylinders.

Things to check: sticking or faulty EGR valve, vacuum leaks on intake manifold gasket near or between the runners for cylinders 4 and 5, clogged fuel injectors, a bad ground for the powertrain control module (PCM or computer), wiring problems to the coils.

Mar 07, 2011 | 2002 Ford Escape

2 Answers

2002 ford escape 3.0L DTC P0305and P0306 what would you ck


P0305 - Cylinder 5 Misfire Detected
P0306 - Cylinder 6 Misfire Detected

When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, The Powertrain Control Module (PCM) or Electronic Control Module (ECM) can determine that a misfire is occurring.

When is the code detected?
- Engine Cylinder #5 and #6 is Misfiring.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/loss of power
- Hard start
- Engine hesitation

Possible Causes:
- Improper spark plug at cylinder #5 and #6
- Insufficient compression at cylinder #5 and #6
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder #5 and #6
- Fuel injector #5 and #6 may be faulty
- Intake air leak at cyli

Possible Solution:
- Perform Injector Service
- Replaced Spark Plug #5 and #6
- Replaced Injector #5 and #6
- Replaced Ignition Coil #5 and #6

Hope helps.

Jan 02, 2011 | Ford Escape Cars & Trucks

1 Answer

Firingorder


2001 Buick Century Firing Order:

V6, 3.1Liter: Firing Order: 123456
While Standing in Front of the Vehicle, the Engine is Transverse, Left to Right, Nearest the Firewall, The No. 1, Cylinder on the 3.1L is closet to the Firewall, on the Left, followed by Cylinder No. 3, then Cylinder No. 5.
Then Left to Right, the Front Cylinder Bank, nearest the Bumper starts with Cylinder No. 2 on the left, Cylinder No. 4 is Center Front, and finally, Cylinder 6 is Front Right.

V6, 3.8Liter: Firing Order: 165432
Cylinder Location:
While standing in front of the vehicle, the 'Back" Cylinder bank, nearest the Firewall, Left to Right: Cylinder No. 2, then No. 4, then No. 6. The Front Cylinder Bank, Nearest the Bumper, Cylinder Location, Left to Right, Start with No. 1, then Center Front, is No. 3, and finally, the right Front Cylinder, nearest the bumper is Cylinder No., 5.

Aug 31, 2010 | 2001 Buick Century

Not finding what you are looking for?
2001 Ford Escape Logo

Related Topics:

4,676 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...