Question about 1995 Ford F250

1 Answer

Oil leaking from oil cooler line

Is changing the two lines from the oil cooler in a 95 f-250 7.3L diesel engine?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Check the o-rings in the female side.

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is there oil in my coolant resevoir,head gasket leak?


Sounds like a warped head take to a mechanic have a compression test done. DO NOT USE ANY GASKET SEALER

Oct 01, 2016 | 1990 Mercedes-Benz E-Class

1 Answer

How to replace oil; cooler on this year


  • Service and Repair
Oil Cooler Replacement

Removal Procedure

  1. Raise and support the vehicle. Refer to Vehicle Lifting.
  2. Drain the engine oil and remove the oil filter housing.
89116492

  1. Loosen the oil cooler outlet (1) and the inlet (2) lines from the engine block.
  2. Lower the vehicle.
  3. Remove the intake plenum.
  4. Remove the intake manifold.
89116493

  1. Disconnect the following electrical connectors from the water crossover:
    • The engine coolant temperature sender (2)
    • The engine coolant temperature sensor (4)
84936658

  1. Remove the water crossover bolts (1).
  2. Remove the water crossover upper and lower seals (2).
84942881

  1. Loosen the upper heat shield bolts on the left side of the exhaust manifold.
89116496

  1. Remove the oil cooler outlet line from the engine oil cooler.
  2. Remove the oil cooler inlet line from the engine oil cooler.
84942883

  1. Note the positioning of the 4 seals.
84972057

  1. Position the oil feed and return,lines out of the way and secure with mechanic wire.
  2. Remove the engine oil cooler, inlet and outlet nuts (1).
  3. Remove the engine oil cooler cover bolts (2).
84942883

  1. Remove the engine oil cooler cover.
  2. Remove the engine oil cooler.
  3. Clean all sealing surfaces.
Installation Procedure
84972056

  1. Install the engine oil cooler.
  2. Apply a 2 mm (0.08 inch) bead of RTV silicone sealant, GM P/N 12346240, in the groove around the engine oil cooler cover.
  3. Install the engine oil cooler cover.
Notice: Refer to Fastener Notice in Service Precautions.
84972057

  1. Install the engine oil cooler cover bolts (2). Tighten the engine oil cooler cover bolts to 30 Nm (22 ft. lbs.).
  2. Install the engine oil cooler inlet and outlet nuts (1). Tighten the engine oil cooler inlet and outlet nuts to 20 Nm (15 ft. lbs.).
  3. Reposition the oil feed and return lines.
84942883

  1. Install the oil cooler outlet and install the oil cooler inlet lines to the engine oil cooler. Use 4 new seals.
Tighten the oil feed and return lines to 30 Nm (22 ft. lbs.).
84936658

  1. Install the water crossover:
    • Position the crossover.
    • Install the upper and lower seals (2).
    • Install the water crossover bolts (1). Tighten
Tighten the water crossover bolts to 30 Nm (22 ft. lbs.).
  1. Connect the electrical connectors at the following locations:
    • The engine coolant temperature sensor (4)
    • The engine coolant temperature sender (2)
  1. Install the intake manifold.
  2. Install the intake plenum.
  3. Raise the vehicle.
89116492

  1. Install the oil cooler outlet (1) line to the engine block. Tighten the oil cooler outlet (1) line to 30 Nm (22 ft. lbs.).
  2. Install the oil cooler inlet (2) line to the engine block. Tighten the oil cooler inlet (2) line to 30 Nm (22 ft. lbs.).
  3. Install the oil filter housing to the engine block. Tighten the oil filter housing to 45 Nm (33 ft. lbs.).
  4. Lower the vehicle.

Dec 22, 2014 | 2001 Cadillac Catera

1 Answer

Engine oil cooler line leaking. Is it easier to bypass the cooler or replace?


its best to replace the oil cooler lines.this should have the lines that run from the radiator to the oil filter housing and when you replace the line you will get both lines as they are made be replaced together.bypassing the line is hard to do takes more time and will leak as you can`t get it to seal properly.

Sep 15, 2011 | 1995 Chevrolet C2500

1 Answer

1990 chev truck, 2 oil lines run behind the oil filter. I have a oil leak from one of those lines. (engine oil leak) What are those lines called and what are they called.


these lines are called engine oil cooler lines and is a common problem.you can only change them in pairs,there is also a gasket or 0 rings seals that should be replaced at the same time were the lines connect to the filter housing.

Mar 24, 2011 | 1990 Chevrolet K1500

2 Answers

I have a really bad oil leak. What could be wrong?


the oil reservoir could have damage. check for the other oil line.

Dec 20, 2010 | 1997 Chevrolet Lumina

1 Answer

Replace oil cooler line leaking


CHECK TO MAKE SURE LINE IS TIGHT IF SO REPLACE THE OIL COOLER LINE ITS LEAKING.

Apr 16, 2010 | 2003 Chevrolet Blazer

1 Answer

Oil cooler lines leaking. Motor losing all the oil within 10 minutes.


Inspect where the oil is leaking from the oil cooler line, it's common for the oil to leak from the remote oil cooler line adapter bolt on the engine block. You can remove the two bolts one at a time and place a oil drain plug washer with some RTV silicon to ensure that it will not leak.

The other common place for the oil line to leak is from where the rubber lines mate to the aluminum line from the remote oil filter line adapter. This is also a simple fix but you're going to need a drumlin tool cut off the old compression clamp that was press fit. Cut off the old compression fitting ring, use cation that you only cut off the ring and replace it with a new compression clamp. Make sure you use compression clamps and not a hose clamp.

This is the best way to fix the oil leak from the adapter line to the rubber hose line, to replace the whole line with the new adapter is expensive and i believe your have to disconnect the engine mount to raise the engine to clear enough room to install the new line along the frame.

Good luck and don't use any engine oil stop leak, it will damage your oil pressure relieve valve and that's one extra thing you don't need to replace.

Feb 15, 2010 | 1997 Chevrolet Suburban

2 Answers

Engin oil cooler


oil cooler is in the radiater

Jun 19, 2009 | 1992 Daihatsu Charade

1 Answer

1998 chevy blazer oil leak


Yes you should be able to change it by yourself. It is pretty simple. It will save alot of money

Jan 30, 2009 | 1998 Chevrolet Blazer

2 Answers

Oil leak


common oil leak on those vehicles is the "quick connects" where the oil lines go into the oil cooler (what i believe you are calling the "doble") replace the o-rings on the quick connects for the lines

Oct 05, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
1995 Ford F250 Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...