Question about 1993 Lincoln Town Car

1 Answer

Brake lights,turn signals will not work

Checked fuses under dash but none blown

Posted by on

  • dave6818 Dec 20, 2008

    yes yes yes

  • David Johnson
    David Johnson May 11, 2010

    how did you check fuses?, have you checked the ones under the hood? Did they all stop working at the same time?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 659 Answers

Try turning the hazards on and off several times these switches go bad and will keep the lights from coming on

Posted on Dec 18, 2008

1 Suggested Answer

  • 173 Answers

SOURCE: broken turn signal

check for burnt out bulbs,this will cause the same thing, turn all lights on and inspect the lights with the turn signal on and the bulb that doesnt work will be dimmer than the rest

Posted on Jan 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signals not working and brake lights not working


replace brake light switch @ BRAKE PEDAL, next, replace turnsignal flasher under dash, check for blown fuse, if turn sig. still doesn't work, check turnsig., switch, & or for loose connection.

Feb 02, 2013 | 1993 Dodge Dynasty

1 Answer

Rear brakelights and turn signals do not work


The turn signal and brake lights are controlled by the turn signal switch.
You did not mention parking lights so I will assume they work.

Could be a faulty turn signal switch or a wiring problem between the dash and the rear of the van.
Do the hazard flashers work on all four corners ?

Jun 27, 2012 | Ford Windstar Cars & Trucks

1 Answer

I have no brake lights. I checked at the fuse box under the hood and found it OK. Then I went to the foot peddle switch and found the switch OK but when I checked for power going into the switch none could...


Do you have turn signals ok?

Is your rear turn signal bolb the same one used for brakes?

Some turn signals are amber and some are red using the same bulb as the brakes. In that case the brake lights go through the turn signal switch.

But you would have power at the pedal switch.

No relay but there should be a fuse in the dash anel or under the hood if you have a battery box under the hood. Your owner manual will tell you where the fuses are and which one is hte brake. Usually a 15 amp.

Mar 21, 2011 | 1994 Honda Accord

1 Answer

Can't get interior dash lights or tail lights to work,i have pulled the fuses and checked them, but they were not blown. My headlights, turn signals, and brake lights work but dash lights and tail lights...


you do have a blown fuse, this car has 2 to 3 fuseboxs, the fuse that holds the dash and park lights is located in the under the hood fusebox, its fuse # 8, heres a diagram of the fusebox in the engine compartment under the hood, hope this helps,36e8e5a.gif

Apr 05, 2010 | 1992 Honda Accord

2 Answers

Lights


turn signals and 4 ways or hazards and brake lights all run the same circuit. Parking lights or marker lights you probably have a blown fuse. Depending on what your vehicle is it may have seperate circuit (fuse), check all your fuses

Sep 11, 2009 | 2003 Ford Crown Victoria

1 Answer

Dash lights-turn signal and rear lights


Access your fuse box and check the fuse labled- rear tail lgts,turn sgns, that fuse is blown, replace the fuse with the same value fuse, while your under there, on the fuse box or next to it you'll find 2 round plug in components, about the size of a Marshmellow, one of these is your flasher unit and the other is for your turn signals, replace both of these, even though one may work, it's just good sense to replace both, that shoud fix your rear lighting problem. good luck.....

Jul 11, 2009 | 1994 Ford Crown Victoria

1 Answer

No brake lights or turn signals on 2008 F450


try checking all of your fuses and see which ones are blown. you have two sets of fuses and they are under the hood of the vehicle and under the dash on the driverside or in the glove box. if the don't work after changing the fuses then your wiring for the turn signals and brake lights need to be cheked from the fuse boxes to the swith for the trurn signal and to your brake lights

Mar 24, 2009 | 1999 Ford Super Duty F 450

1 Answer

Tail lights and dash lights not working


there are a few fuses under the hood be sure to check fuses again at dash they could look good but not be and if one was blown it could have blown as soon as you turned them on again that would indicate a short. it could be the switch also if it is the pull type try pulling it slowly to see if they come on and turning it like to dim the dash lights. if that makes them come on you need a new switch sometimes it will work sometimes not

Dec 23, 2008 | 1992 Mercury Cougar

Not finding what you are looking for?
1993 Lincoln Town Car Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...