Question about 2001 Ford F250 Super Duty Super Cab

1 Answer

4X4 on 1999 superduty F250 diesel 7.3 doesnt work.

Where the heck is the fuse located?

Posted by on

  • 2 more comments 
  • mopnmore Dec 18, 2008

    the fuse for the 4X4 thing.It was working fine and then the truck was turned off with the 4X4 still engaged and it would not work again. imagine how silly I looked in the snow, with a great big 4X4 that was slipping and sliding all over the place. I am assuming it is the fuse...but I don't know where the darn thing is. Is it in the cab or under the hood and where would it be ?

  • mopnmore Dec 18, 2008

    Thank you. If it is not the fuse..... would you have any suggestions as to what else it could be? We have had nothing but problems with this truck, and this is just one more thing to add to the endless list. Thank you for your time.

  • mopnmore Dec 18, 2008

    Thank you! I have a hammer.

  • i2shoe Jan 29, 2009

    I have a 1999 F250 SD that won't shift in to 4 wheel drive anymore. I've replaced the Transfercase motor put in new fuses and now I'm out of ideas. It worked just fine until I turned the truck off and when I restarted the truck it never worked again. The swith on the dash no longer light up either



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

To what?

Posted on Dec 18, 2008

  • 1 more comment 
  • milespeed Dec 18, 2008

    big panel ..lower dash..where your knees are...under steering wheel

  • milespeed Dec 18, 2008

    the power distribution box is located in engine compartment near brake master cylinder

  • milespeed Dec 18, 2008

    if you have these electrical gremlins running rampant ... check powers and grounds to all things primary electrical... grounds especially...mechanically it could be jammed and need rotated to free itself from hub locking 4x engagement...a hammer? it is snowing and that can cause many issues..warm it /dry it.. then try to engage /disengage and get it freed up...good luck



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

F250 no air from dash vents, works on floor and defrost

Possibly some blockage? Foam where it shouldnt be?

Nov 07, 2013 | Cars & Trucks

1 Answer

Where is the fuse box located on a 2005 Ford Superduty F250 Diesel?

One is under the hood and the other below the steering colomn.

Jan 28, 2011 | 2005 Ford F 250 Super Duty

1 Answer

How complicate is it to replace thermostat in my 2000 f250 superduty

it should not be too difficult, but what is it, a diesel or a gasoline engine? most of the time the thermostat is located on the engne next to the radiotar hose coming of off the radiator going to the engine.

Dec 18, 2010 | Ford F-250 Cars & Trucks

1 Answer

I have a 2001 F250 Superduty 7.3l Diesel. When I

I had a problem with vacuum in my F250 diesel. It had a new vacuum pump but would kick out of cruise control every time the vacuum pressure dropped. It turned out to be the vacuum reserve cannister had holes in it.

Seems you reach a tipping point and then all the vacuum systems mess up. You might want to check the reserve cannister and any vacuum servo your 4x4 might have. You can check most of the vacuum stuff with the engine OFF using a vacuum pump. You could have a leaking vacuum pot operating the ductwork. Check your diesel vacuum pump for output and loose belts.

Jan 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

I have a 99 superduty diesel f250 the heater is stuck on defrost, no fuses are blown, i tried a new set of switches on the front still it doesnt help, i just need to no what to look at next,

make sure the hoses down by the right side kick panel didn't come unplug from someones feet. then make sure the vaccum pump on the right side fender is working. when there is no vaccum it will go to defrost

Dec 18, 2009 | 2001 Ford F250 Super Duty Super Cab

2 Answers

Need fusebox diagram for 2003 F250 superduty 4x4

I have a ford f 250 4x4 2003 and my horn doesnt work and the overhead compass/information instrument will not turn on. the airbag light blinks a few times them stays on. whats the deal?

Dec 11, 2008 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

2002 F350 Superduty 7.3L Diesel/Auto transmission

You should check the wiring for the gear shift. Sometimes the wires rub through on the top and it causes a short.F2.45 is a 10a fuse in fuse box located in the cab. It controls all three of your concerns. Hope this helps, Good Luck.

Sep 01, 2008 | 2002 Ford F250 Super Duty SuperCab

Not finding what you are looking for?
2001 Ford F250 Super Duty Super Cab Logo

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides