Question about 1993 Toyota Land Cruiser

1 Answer

75 series ute rear hub hot after a drive

Hi, Last night I found that my right hand read hub was very hot after a drive. The question is was are the possible causes?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

More than likely its a binding brake. i.e. a sticking wheel cylinder not allowing the shoes to return or a sticking handbrake cable or lever inside the drum.
Last possibility is a worn wheel bearing but thats unlikely to produce a great deal of heat unless it was about to break up. This would be apparent by a fair amount of noise. I'd bet on the first suggestions though.
Cheers John

Posted on Dec 17, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace my hand brake cable on my ford falcon XH ute


wait a bit ....is it rear disc or rear drums on that ute

will assume its under dash hand brake pull lever tyoe

the disc setup may have single cables for each rear
rear disk brake cable is approx $ 150

if your XH it is close to the XE and XF set up drums
a complete one line loop cable outer and inner
with plastic grommets along the back chassis rail ( they break )
so the one inner cable works both rear handbrake shoes


hand brake cable is a shorty

undo the adjustment thread
just below the hand brake cable point up somewhere above the gearbox
(drums )
after new cable fitted
drums are adjusted with the old school way with the handbrake adjuster tool
handbrake cable adjusted

then the handbrake handle when pulled out to hold needs14 plus clicks
comes out a long way for some weird reason
on drums
if cable adjustment is done wrong onrear drums the handbrake cable will come loose in the drum as you drive along

26261095-l1jraapkfcyxqeqgczv0cruv-4-0.jpg

26261095-l1jraapkfcyxqeqgczv0cruv-4-3.jpg

26261095-l1jraapkfcyxqeqgczv0cruv-4-5.jpg

Aug 17, 2016 | Ford Cars & Trucks

1 Answer

60 series wagon


We have no way to look this up here at fixya. Contact a salvage yard, they have cross reference manuals.

Jul 24, 2012 | 1985 Toyota Land Cruiser

1 Answer

75 series landcruiser has no power


It is time to get the engine checked for the error code. The fault can be relative to many issues but primarily the fuel and firing timings. So also the compression and valve timing must be checked. Make sure that there is no brake jamming or faulty bearing , check all wheels for free movement.

Jan 07, 2012 | Cars & Trucks

2 Answers

How to determine if rear wheel bearings need replaced


If they are very bad car will have loud rumble sound that can get better or worse when cornering. To really check you need to remove rear brakes and try to spin hub with no load. If it spins smooth and easy and has no rough feel or barely moves by hand the hub is bad. Most front drive cars have hub with both inner and outer bearings included. Just replaced them on brother in laws Accord last night and it was only $60 for each at Advance - $129 for both sides, whole hubs with bearings, seals, and ABS ring included.

Apr 04, 2011 | 1999 Volkswagen Cabrio

1 Answer

Falcon ute lights go dim at night and battery goes flat.


either your alternator is faulty or your battery is not holding charge
i would check the alternator and the battery and replace either or both

Jul 08, 2010 | Ford Futura Cars & Trucks

3 Answers

Hot tire


you may have two problems sounds like either a brake hose or caliper problem also may have play in front hub bearing

Mar 21, 2010 | 1992 Ford Taurus

1 Answer

The abs light is always on while driving and the right tyres vibrate on speed


There is a good chance that the right wheel hub has gone bad and needs to be replaced. The ABS sensor is apart of the wheel hub, there is a speed ring on the wheel hub for the ABS sensor to read which will activate the ABS when wheel lock up is detected. When the wheel hub is damaged or worn, the speed ring is no longer lined up with the sensor and will need to be replaced. A bad wheel hub can also cause the wheel to come off if the bearing inside fail and seize causing it to explode.

Good luck and have your wheel hub replaced soon as possible and try not to drive it on night way speeds till your repalce the wheel hub. Thank you for using Fixya.

Mar 08, 2010 | 2000 Mitsubishi Galant

1 Answer

1998 f150xl regular cab brakes grab


I had a similar problem with the front disc brakes .... had to replace the calipers. In high corrosive conditions the pistons on the calipers can become contaminated and not operate smoothly ... they stick. The same thing can happen to the wheel cylinders on the rear. Try replacing the wheel cylinders on the rear (fairly cheep fix) and if that fixes them then the calipers would be next. Jim

Dec 18, 2008 | 1998 Ford F150 Regular Cab

1 Answer

I think the water pump/thermostat are bad. Car is overheating and have changed radiator resevoir. Check engine light is on. Can you send me diagram of motor


Not sure if there are two thermostats, I know of one that I changed, it sits right above the starter and right below your air box. I had the problem my guage was reading hot on a cool night so I went and popped the hood and (after cooled) opened the radiator resivoir and the results were dry as a bone. I had steam coming from the cap. if you so this be sure to slowly release the pressure from the red cap that reads HOT WARNING DO NOT REMOVE. that is where you pour the coolant/water mix.

After I did that I took it to a shop and had it flushed, cleansed and refilled.....then I was runnin a beutiful bright green. Cost about 69.99 for flush then I found out my water pump pully was locked up and not rotating (not pumping coolant). So I fixed that last night and she's runnin pretty good after 190,000 miles.

Good Luck Mazda's

Aug 05, 2008 | 2000 Mazda 626

Not finding what you are looking for?
1993 Toyota Land Cruiser Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...