When i put factory radio back in the 2 wires going to the gem module sparked now i dont have wipers or speedometer working everything else works fine
SOURCE: 2003 Ford Explore 4x4 stuck in 4x4 Low
Try backing up in 4x4 then put it in N and shift out of 4x4
SOURCE: Gearshift locked, no power windows, interior lights, wipers
For starters, do you have brake lamps? The shift lockout is controlled by the brake switch. As far as the others, yes it could be the GEM (generic electronic module) some of these vehicles have water intrusion problems that leat into the fusebox and GEM which is located on the back of the fuse box. If you can look at the fuse box inside the vehicle and if you can see the back, look for corrosion which is a sign of water.
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: Ball joint replacement-2003 Ford Sport Trac
if you dont have a ball joint press and dont know how to use one then dont do it, but if you do its not that bad of a job just jack the truck up under the control arm remove the brake rotor then take the lower ball joint nut off then use a pickle fork to break the ball joint loose then take the axle nut off push the axle out of the bearing and use the ball joint press to remove and replace the ball joint
256 views
Usually answered in minutes!
i fixed problem changed every fuse in panel on side of dash everything is working proper
×