Question about 1995 Chevrolet Blazer

1 Answer

1995 Chevrolet Blazer

How do I replace my break line?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 85 Answers

In order to replace a breakline you must first measure the line then go to your nearest autoparts store and give them the measurements of the line and inform them what vehicle its going in to. then with a wrench disconnect both ends of the line. then replace it with a new one. make sure no liquid drips off of the other brakeline. then fill up the mastercylinder which is located under the hood. thats where you fill it up with brake fluid.then have someone pump the brakes 5 times holding on to the brakes loosen a nipple on the disk brake or drum depending where the line is located its with a 10mm depending on the vehicle while still pressing the brakes tighten the nipple. then redo the pumping until all the air is out the liquid will start to purge out. remember to fill the master cylinder.

Posted on Sep 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the freeze plugs located on a 1995 Chevrolet Blazer?


There are three on each side of the block(one under each engine mount) there are three of them in between the engine and transmission. There are also some in the heads(maybe, I can't remember the year they stopped doing these), front and back.

Oct 16, 2014 | 1995 Chevrolet Blazer

1 Answer

BLEEDING BREAKES WITH ABS SYSTEM 2000 BLAZER


Probably will have to bleed the master cylinder.

Sep 25, 2017 | 2000 Chevrolet Blazer

1 Answer

Vacuum line diagram


Hi there:On 1995 CHEVROLET TRUCK BLAZER 4.3L CPI 6CYL check this...

7_6_2012_2_21_27_pm.gif

Fig. 30: Engine vacuum schematic - 1995 4.3L (VIN Z) engines



Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jul 06, 2012 | 1995 Chevrolet Blazer

1 Answer

TRYING TO FIND A CHEVY BLAZER BREAK LINE CANT FIND A REPLACEMENT ANYWHERE IN BROOKLYN ANY SUGGESTIONS


You can order them online at redlinemotive.com. There toll free line is open 24/7: 1-888-311-9409.

Feb 18, 2011 | 2000 Chevrolet Blazer

2 Answers

Air conditioner blows air out the defrost duct and lower heater duct


check the vacuum line going to the cotrol panel in the dash. it could be broken or the plug on the back of the panel came off. the line usually breaks under the hood

Jun 16, 2010 | 1995 Chevrolet Blazer

1 Answer

Describe your 1995 Chevrolet Blazer Probl1994


First thing, check for vacuum leaks. Wiggle all hoses while engine is running and listen for a hiss. Check all intake bolts for tightness. Dump some soapy water along the edge of the intake where it joins to the head. If it bubbles a lot, your intake gaskets need replacing. Change plugs, wires. Change cap and rotor. Change fuel filter. Do that much and get back to me if no change.

Jul 28, 2009 | 1995 Chevrolet Blazer

1 Answer

Need to replace the oil lines on 95 chev blazer is it hard to do


It's harder then it seams, you have to disconnect the engine mount on the drivers side to get enough room to remove and replace the old oil lines. Other then the engine needing to be raised a bit, it's simple. Good luck and hope this helps, it takes about 3 to 4 hour to do this job. 

Jul 13, 2009 | 1995 Chevrolet Blazer

1 Answer

Service Engine Soon Light and Rough Idle (Below 1200 rpms)


do you get check engine codes?..have you done a leak down test and compression test to determine mechanical engine health?

Oct 07, 2008 | 1995 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...