Question about 1998 Toyota Camry
What are the steps?
This Ones Fun It Must Be Very Common As I Just Did It To My 99.
Step 1. Remove Negative From The Battery.
Step 2. Put The Key In The Ignition And Put It In Acc Position.
Step 3. Remove The Steering Wheel Column Covers. I Think 2 Screws On Bottom
Step 4. Unplug Wiring Harness From Ignition
Step 5. Detach The Switch Retaining Screws.
Step 6. Look To The Bottom Of The Ignition And There Is A Youll See The Retaining Pin Push It With A Small Flat Head Screw Driver Or Alike.Then Pull The Key While Holding That Pin Down
And Bam There It Is In Your Hand.
Then Reverse All These Steps Once Sliding In The New Ignition.
If For Any Reason You Do Not Understand Please Feel Free To Ask Me Any Questions.
Posted on Jan 06, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 1998 toyota
There is a pin that you have to push in on the bottom of the lock cylinder housing.It is recessed in a hole.You have to turn the key to acc or on to get it to push in.Once you push it in you can pull the key and lock cylinder out.
Posted on Dec 02, 2008
To remove the ign lock cyl, remove the lower plastic dash panel to gain access to the lock cyl housing. Inset key and turn to acc posistion. (one click off lock). Locate the release pin hole on the right/bottom of the housing and with a small screwdriver push it in while pulling out with the key. I cyl sould pull out. Reverse for install. Make sure the new lock cylinders pin is pushed in to install. It only pushes in in the acc position.
Posted on Apr 19, 2009
your problem is damage window regulator, you can change it by removing the trimboard first to give way in removing the old window regulator assembly.
Posted on May 06, 2010
MOST TOYOTA LOCK CYLINDERS, HAVE A RELEASE PIN OR LEVER. WHEN YOU BUY THE NEW LOCK IT WILL PROBABLY HAVE INSTRUCTIONS, OR YOU CAN SEE HOW THE OLD ONE COMES OUT
Posted on Jan 11, 2011
Tips for a great answer:
May 26, 2011 | 1998 Toyota Camry
Aug 06, 2010 | 1998 Toyota Camry
Jun 01, 2010 | 1998 Toyota Camry
Jan 22, 2018 | 1998 Toyota Camry
Jun 03, 2009 | 1998 Toyota Camry
Apr 27, 2009 | 1998 Toyota Camry
Mar 09, 2009 | 2001 Toyota Camry
343 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: