- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your seat belt light is controlled by the Driver seat belt only so, check to make sure the plug is plugged in on that seat belt! Has that seat been removed lately? Maybe it was just forgotten to be plugged back in! Good Luck...
you will have to be patiant with this as long as the seat belt tensioners havent gone try to pull the belt so some tension comes of it so it can roll back into the spool or jiggle it by bulling on it quickley should be a simple fix hope this helps
Remove the panels to the belt, normally these can miss roll and get stuck. Unbolt the unit so you can get some slack that should be enough to release and pull it back out to correct it. If that will not do it get a replacement from a junkyard and replace.
I assume you've already worked the seat belt end back and forth with force. Did the belt move at all? Did you remove the rear seat bottom cusion from the car? That will give you additional leverage on the belt. If the belt twisted the last time it was used and then rolled up, you need to go to the dealer or an upholstery shop for help.
You have to actually unbolt the belt holder behind the seat. Then from there you can check to see if the spring still works. You'll probably have to take the cap off it, wind the spring-load, then put the cap back on. If you can get to it, it's not too difficult. I recommend another pair of hands to help hold if they're available. You'll also want to make sure you've rolled the belt up as much as possible before before you coil the spring-load.