Question about 1994 Ford Aspire

1 Answer

Loosing power 1&2 start dies when apply gas

Started hesitating in second gear then first now dont want to crank and when it does dies by it self or when i apply gas pedle

Posted by on

  • Anonymous Dec 21, 2008

    Applied Gas from a stop at a light and it will not start again,Checked fuel pumps, wires, too much stuff to list what is wrong

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

Hesitation can be caused by the spark dropping out. This could be related to a faulty distributor. Try installing an in-line spark tester (can buy at any auto parts store for a few bucks) and see if the spark drops out when you rev the motor up and it begins to hesitate. If so, it is likely the distributor has gone bad.

Posted on Jun 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1987 Pontiac 6000 it starts then dies before you can shift it into gear.


Clean throttle body bore and plate and see if that helps. If not, post back.

Jul 21, 2015 | Pontiac Cars & Trucks

1 Answer

Loose gas cap


loose gas cap is just that. it means the gas tank venting system
is breached, cap is 99% cause, but not all. and will not cause no starts. unless you put a non jeep gas cap on car, with no spec, vacuum breaker in the cap and the vent goes to vacuum , killing the pump output, to low. and no starts . (use real caps)
so if that is try , take the cap off, and key on 3 times for 5sec
(this primes the system) then crank, start now>?


no start
but will it crank
if and if it cranks robustly does it run for 1 or 2 seconds and stop>
do you have spark ? at all cylinders. engine option not stated, so...??????????

if it cranks and dont start here is the ASD rule page
http://www.fixkick.com/Jeeps/ASD.html

the story of the chicken and egg.
what comes first?

Apr 01, 2014 | 2006 Jeep Cherokee Limited

2 Answers

1995 honda odyssey starts and then dies


Isince it cranks, means you have power, elctric system is ok! I guess.. this could be a result of gas delivery problem... either a pump or gas circuit controller.... OR a small propable reason if you have an immobilizer (electronic chip on key!)... but there should be the securit key highlithed on dashboard...

Sep 01, 2012 | 1995 Honda Odyssey

1 Answer

1990 Chevy Van with a 350 small block that has a mind of it's own.


Try to get it running a bit to warm up the exhaust. Take a point and shoot thermometer and take the temp of the cat. If temps exceed 400 degrees I would start to suspect a plugged cat.

Mar 05, 2017 | Chevrolet Cargo Cars & Trucks

1 Answer

I have a 93 Dodge Colt 1.5 liter engine. I've noticed in the last month or so after it starts that the idle seems to go high and take 15 or 20 seconds to get back down to normal. Two days ago I went to the...


Its probably your computer. Had the same thing happen to me about ten years back. About 500 dollars. better off finding one on ebay or at a junk yard.

Aug 09, 2010 | 1993 Dodge Colt

1 Answer

92 Jeep Cherokee Laredo 4.0 6cyl. (193,000 mls) Loss of power.


Try some "heet" , STP gas treatment or the like. sounds like you might have some bad gas.

Mar 13, 2017 | 1992 Jeep Cherokee Sport

2 Answers

Random Hesitation


yes i do think that the converter would do that it did it to me on my chevy cavalier and that is what is was

Apr 07, 2010 | 2000 Volkswagen Jetta TDI

1 Answer

96 chevy s-10 will not start in the am


try a new fuel filter. also check your fuel pump.

Jan 18, 2009 | 1996 Chevrolet S-10 Pickup

1 Answer

Will not idle when cold and hesitates when warm.


check your idle air motor. when i first got my car it did the same thing. check and make sure its not loose or check and make sure you dont need a new one.

Nov 23, 2008 | 1986 Pontiac Fiero

2 Answers

Bronco Wont Start (help please)


Check for timing gear problems. They have plastic teeth on the cam shaft gear which will shatter causing it to jump time.

Aug 03, 2008 | 1981 Ford Bronco

Not finding what you are looking for?
1994 Ford Aspire Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...