Question about Hyundai Motor 2003 Elantra
When I place the key into the ignition all the dashboard lights turn on and the sounds chime as well; as I try to turn the car on I get nothing, no sound at all! The dashboard lights are still on. My car is a manual transmission so I have to press down on the clutch pedal to start it. I had the car 'jumped' and it still didn't turn on. The only way I can get it started is by 'push start'. I 'pop' the clutch in 2nd gear. When I'm driving, the car is fine. It doesn't die out on me. I figure it's the starter that is bad. Is it the 'starter' or the 'starter solenoid'? Any thoughts anyone?
Could be a problem with the clutch pedal switch. I'd have a look under the dash first to make sure no wires have been knocked of the pedal switch. If there's no sound, not even a clunking sound it may be the solenoid. I'd first want to eliminate the pedal wiring. Remove the small wire on the starter (most likely a spade type terminal) and using a piece of insulaated wire attach it to the starter where you removed the spade. Flick the other end of the wire on the positive of the battery. If the starter operates your looking at the pedal switch/ relay fault. If not its the starter. MAKE SURE CAR IS IN NEUTRAL BEFORE TRYING THIS. Ignition switched off. That way it will crank but not start.
Posted on Dec 17, 2008
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2004 hyundai santa fe parked it
The 04 Santa Fe came with three different engines. 4 cylinder (2.4 lit), and two different V6's (2.7 lit & 3.5 lit). The 2.4 & 2.7 use throttle cables connected directly to the throttle plate, but the 3.5 uses ETS (Electronic Throttle System) which uses two sensors (APS & TPS) and a control module (ETSCM). APS=Accelerator Position Sensor, TPS=Throttle Position Sensor, ETSCM= Electronic Throttle System Control Module. There are different diagnostic procedures for each system.
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, campaigns, illustrations and procedures, etc.
Posted on Sep 10, 2011
Tips for a great answer:
Jan 04, 2016 | Hyundai Cars & Trucks
Nov 21, 2012 | 1995 Hyundai Elantra
Aug 20, 2012 | 2003 Hyundai Elantra GLS
Oct 03, 2009 | 2000 Hyundai Elantra
Sep 26, 2009 | 2000 Hyundai Elantra
Sep 06, 2009 | 2007 Hyundai Elantra Limited Sedan
May 13, 2009 | Hyundai Motor 2003 Elantra
May 12, 2009 | Hyundai Motor 2003 Elantra
1,059 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: