Question about 1998 Ford Taurus

1 Answer

Blower not working

I have a 1998 ford taurus and the blower will not come for the heat or the A/C. All the fueses are good

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

Probably a bad blower motor. check for rust corrosion inside from water dripping on it from air intake at base of windshield under screen.

Posted on Feb 25, 2009

6 Suggested Answers

Molson02536
  • 3854 Answers

SOURCE: 1998 ford taurus blower won't work

Check the fuse box under the hood and look for the a/c heater blower fuse, check to see if it's gone bad and needs to be replaced. The other thing to is check if the blower fan works on high setting only, if it does, then the blower motor resistor has gone bad and needs to be replaced. Once you have gone through all the electrical fuse and relay, then good chance that the blower motor needs to be replaced. If you go to Auto Zone they will have the blower motor and resistor if you want to replace that too and they will have the step by step instructions for you to get the job done with common tools. Good luck and keep me posted, be glad to answer more questions you may have. 

Posted on Jul 01, 2009

shocktroop40
  • 155 Answers

SOURCE: Blower on the heater/AC not working on 1998 Escort, checked fuse under dash?

Ok, first off, check the fuses under the dash. If they're all good, does the blower work only on high speed? If yes, then you have a bad blower motor resistor, which is located under the hood, near the blower motor itself. If the motor doesnt work at all at any fan speed, make sure the wiring harness that plugs into the motor under the hood is clean and tightly installed. If it still doesnt operate, sometimes tapping on the blower motor housing will kick it on, but if that doesnt work, you may have to replace the blower motor. They are available aftermarket, and arent usually too expensive.

Posted on May 24, 2009

  • 21 Answers

SOURCE: 1998 ford Taurus 24v DOHC Overheating not thermostat

check to see if eans coming on if they dont then its fan relay if they are the rad is pluged or ther is an air pocket in the cooling system there should be a bleeder on it

Posted on Oct 06, 2009

emissionwiz
  • 60792 Answers

SOURCE: 2000 Ford Taurus heater blows cold air ?

this problem is caused by a part called the "temperature control blend door actuater motor" this litttle motor drive moves the door that diverts air over the heater core or AC evaporator core, when it fails it almost alwys fails in the AC only position, u will need to have the motor drive replaced

Posted on Oct 16, 2009

wfservices
  • 260 Answers

SOURCE: alternator removal 1998 ford taurus dohc

3.0L (4V)
Removal

  1. Disconnect the battery ground cable.
  1. Remove the accessory drive belt from the generator pulley.
  1. Remove the power steering line bracket and heater hose support bracket from the generator.
  1. Remove the upper generator bolts.
  1. Partially raise the vehicle on a hoist.
  1. Remove the right front wheel.
  1. Remove the lower fender splash shield retainers and position the shield out of the way.
  1. Remove the generator splash shield.
  1. Raise the vehicle.
  1. Disconnect the electrical connector and remove the battery positive cable from the generator.
  1. Position an adjustable stand to the subframe.
  1. Remove the right subframe bolts.
  1. Remove the lower generator bolt.
  1. Lower the subframe to provide clearance.
  1. Remove the generator.
Installation
  1. NOTE: Do not tighten the lower bolt.

    Install the generator and the lower bolt.
  1. Raise the subframe and install the subframe bolts. Tighten the bolts to 90 Nm (66 lb-ft).
  1. Remove the adjustable stand.
  1. Lower the vehicle.
  1. Install the upper generator bolts and tighten them to 25 Nm (18 lb-ft).
  1. Install the power steering line bracket and the heater hose support bracket. Tighten the nut to 20 Nm (15 lb-ft).
  1. Install the accessory drive belt. Refer to Partially raise the vehicle.
  1. Tighten the lower generator bolt to 25 Nm (18 lb-ft).
  1. Connect the generator electrical connector.
  1. Install the battery positive B+ cable and nut. Tighten the cable nut to 10 Nm (89 lb-in).
  1. Install the generator splash shield.
  1. Install the fender splash shield and the retainers.
  1. Install the right front wheel.
  1. Lower the vehicle.
  1. Connect the negative battery cable.

Posted on Mar 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat


do you have a heater core connected, with the heater hose?,
does the blower inside de car works?
if yes the problem is your blend door actuator

Dec 05, 2013 | 1998 Ford Taurus

1 Answer

Blower for my heat not working in 1993 ford taurus


take a small hammer and tap on the blower motor
with the car running and the switch for the blower on
if it starts to blow
put a new blower motor in it
if not then it get lots deeper into electrial

Jan 10, 2010 | 1993 Ford Taurus

4 Answers

2001 Ford Taurus Heater blower not working


heater is not blowinig warm air.

Sep 30, 2009 | 2001 Ford Taurus

1 Answer

1998 ford taurus blower won't work. Heat won't go on or the a.c. How can this be fixed or what is the cause of the problem?


Check the fuse box under the hood and look for the a/c heater blower fuse, check to see if it's gone bad and needs to be replaced. The other thing to is check if the blower fan works on high setting only, if it does, then the blower motor resistor has gone bad and needs to be replaced. Once you have gone through all the electrical fuse and relay, then good chance that the blower motor needs to be replaced. If you go to Auto Zone they will have the blower motor and resistor if you want to replace that too and they will have the step by step instructions for you to get the job done with common tools. Good luck and keep me posted, be glad to answer more questions you may have. 

Jul 01, 2009 | 1999 Ford Taurus

1 Answer

No air at all. no a/c no heat


it sounds like the blower motor resistor assembly
it is located on the left side of the duct assembly for the most part it is on the passengerside behind the glove box
www.taurusclub.com this is a website I found to help me out with my taurus too, :)

May 02, 2009 | 1998 Ford Taurus

1 Answer

Heater blows out cold air half the time


Check the coolant level. It might be air buble in a heater core. Also it might be water pump problem.
Good Luck

Dec 12, 2008 | 1998 Ford Taurus

1 Answer

No heat


if the engine temp is good (approx 200 degrees) you may have a clogged heater core. if engine temp is too low (less than 160 degrees) you may need thermostat

Dec 07, 2008 | 1998 Ford Taurus

1 Answer

BLOWER FAN RELAY SWITCH


check your blower resister by the blower and se if your getting power in and out of it,either its bad or the blower its self

Jun 10, 2008 | 1998 Ford F150 Regular Cab

Not finding what you are looking for?
1998 Ford Taurus Logo

Related Topics:

306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...