Question about 1990 Jeep Wrangler

1 Answer

1990 Yj Jeep Wrangler

I am having a problem starting. The batt. is good, starter is good, Can roll it down a hill and it will start. Is their a fuse somewhere that could be bad?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

Is it cranking the engine ?? If not then something is wrong the connection to the starter.Look for a bad connection to the starter. It could also be the starter solenoid. The best advise i can give you is to get it scanned for an error code for free at many parts stores. all youhave to do is ask if they do that.I know they do it at Autozone.

Posted on Dec 17, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 89 yj , i just replaced altenator , battery , positive cable , ground cable, put an hei distributor on it with new plugs and wires and a solenoid and my voltmeter is in the red after about 15 run...


I would think your starter is over heating (grounding) which is draining power from batt which is making alternator use its charging capabilities to the max . starter motor is what id check. this isnt a little 14 gage wire robbing all that power so quick, it is a direct connection within the batt,starting or charging system.

Jan 11, 2011 | 1989 Jeep Wrangler

1 Answer

Just replaced the tranny on my 1990 jeep wrangler 2.5l. when i connected the batt cable to turn on the flashers the hot wire off the starter was touching the side of the stater. there was a little smoke...


check for power in the big fuse box sounds like you have overloaded a cable from the battery to this supply box also make sure the earth from engine to chassis is connected

Oct 22, 2010 | 1990 Jeep Wrangler

1 Answer

1990 Wrangler: I have a 1990 yj with the 4.2, my question for eve...


Most 90 wranglers from 89 to 95 have an ax15 5 speed transmission in them. The 4 cylinders had an ax5 transmission.

May 17, 2010 | 1990 Jeep Wrangler

1 Answer

My1995 Jeep Wrangler is hard to start when it is


CHECK BATTERY VOLTAGE.IT SHOULD BE 12.5 VOLTS.IF BATTERY OKAY.YOUR FUEL FILTER COULD BE STOPPED UP.OR YOU NEED NEW PLUGS + WIRES + CAP AND ROTOR.

Apr 18, 2010 | 1995 Jeep Wrangler

1 Answer

95 wrangler yj. has no power at high speeds


Have you had fuel pressure tested, and/or filter changed. Have you checked for plugged exhaust, such as catalytic converter? Quite often engine will also run a little hotter than normal when exhaust is plugged.

Nov 05, 2009 | 1995 Jeep Wrangler

1 Answer

Missing factory throttle linkages on 1990 YJ jeep. Need Diagram


Go to any scrapyard and you can get the entire setup for next to nothing...and you can see how it's hooked up!!!

Jul 07, 2009 | 1990 Jeep Wrangler

3 Answers

1990 Jeep YJ 6 cyc. Won't Start---No Spark From Coil


It would be great if you could find the Ignition Control Module!!! From my experience on my Jeep...90 YJ 4.2 liter carb. it does not have one...Computer controlled only...

May 17, 2009 | 1990 Jeep Wrangler

1 Answer

Soft top-1993 Jeep Wrangler YJ


OK I have a yj and you start from the windshield put the snaps/or what ever yours is on the top of the doors then down the side or the doors then under the back side window then around the curve and this is the hardest part then your tailgate also make sure your bars on the inside are loseuntil the top is on then thighting those bars and you should have a nice tight top but belive me it is hard and you might need a flathead screw driver for the corners. Good luck and a jeep wave to you!

Apr 03, 2009 | 1993 Jeep Wrangler

1 Answer

What type of transmission do i have?


Your Wrangler is a YJ and the model is an "S". A Wrangler manufactured in 1987 through 1995 are all YJ's and then from 1997 through 2006 are all TJ's. The new Wrangler models are dubbed JK's.

Feb 22, 2009 | 1990 Jeep Wrangler

Not finding what you are looking for?
1990 Jeep Wrangler Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...