Question about 2007 Chevrolet Impala LS Sedan New Cars

2 Answers

2007 chevy impala brake light and left turn signal not working

The rear driver side brake light and turn signal does not work, but when I checked the bulb it was working just not when I press the brake or use the turn signal. The left turn signal on the dash also blinks rapidly. Is it still the bulb needing to be replaced or is this something more involved?

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 41 Answers

Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Posted on Aug 07, 2012

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 3 Answers

I have some problem on a 07 Chevy impala the left brake nor turn signal work I changed the bulb I changed the whole tail light I even change the tail light wiring harness the left still don't work fusees or good the bulbes good the third tail light work an the right ta

Posted on Apr 13, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: No rear brake light / turn signals on 2001 Chevy Cavalier

The problem is the turn signal/headlight/hazard switch assembly on the steering column which the brake light wiring runs through. The part is easy to change and cost about $50 at most parts stores

Posted on Sep 05, 2008

kidspeedy
  • 321 Answers

SOURCE: left rear turn signal light on my 1999 chev. s10 is not working

any increase in bink speed is direcly related to a bulb being burt out.

Posted on Jun 12, 2009

  • 1 Answer

SOURCE: brake light on 2001 chevy blazer LT 2wd

When my blazer did this they had to replace part of the wiring harness in the steering wheel. It took forever for them to get the parts because we live in nowhereville, but once it was in it works again and no problems. I had to take it to the actual chevy dealer because none of the other places had a clue. good luck.

Posted on Jul 31, 2008

  • 3 Answers

SOURCE: 1997 Chevy Cavalier Turn signal problem

could be the flasher.

Posted on Jul 31, 2008

  • 5 Answers

SOURCE: Chevy Cavalier 2001 turn signal blinks fast

If new bulbs don't work, it is probably the harness that holds the bulb. I had to replace both on my car after fighting with the problem for over a year and not knowing.

Posted on Mar 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

07 Impala rear driver side brake light and turn signal does not work, but when I checked the bulb it was working just not when I press the brake. The left turn signal on the dash also blinks rapidly.


Sounds like a possible bad ground connection.
Make sure the contacts for the bulb are clean.
Make sure the cround connection is not corroded.

May 21, 2015 | 2007 Chevrolet Impala

1 Answer

Left bleaker and break light not working. Turn signal works bleaks faster than right side.


Has the vehicle been in an accident on the left rear side. First check the bulb to be sure it is not defective, trade it out with the side that works properly to test. If the bulb works well then My thought are you may have a shorted wire. The turn signal flasher works by heat build up within the flasher the heat is caused by the load of the bulbs, the load heats the metal spring causing it to open the circuit then as quickly as it cools down the circuit closes again lighting the bulbs.
There is also a possibility of a defect in the turn signal mechanism on the steering column. The turn signal switch on many models does three different things on many models that use the same bulb element / or bulb for brake and turn on rear of vehicle. It controls the circuit for brake light by sending power both left and right side rear when turn signal is in neutral position then when turn signal is in left turn the switch cancels brake light power to left side rear and supplies flasher power to left side while maintaining brake light supply to the right side rear, and so on opposite when the right turn is chosen on turn signal switch. The turn signal indicators on the dash normally run off the same circuit as front turn signal bulb only which is also controlled by turn signal switch. Front has turn signals but no brake light.
I think there is an additional load on the left side rear turn circuit and it could be either a wire that is shorted or the turn signal switch if the same bulb element is used for both functions.
Often times if trailer lighting is connected the flasher will also blink a little faster because of the extra load of additional bulbs.

Feb 15, 2015 | Cars & Trucks

1 Answer

2005 impala rear (passenger side) blinker and brake light wont work... the parking lights work fine. I changed the turn signal light figured that was the problem since the front passanger blinker works...


Any idea's ? Yes , learn how these system's work ! Looking at wiring diagram's to see what all is involved in the electrical circuit's for the brake & turn signal lamps . Plus learning how to test electrical circuit's with a DVOM - digital volt ohm meter .
Electric Testing Techniques You Need to Know
Testing is how to find this problem , not going by someone guessing who has not even looked at the vehicle ! Free wiring diagram's here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model an engine size . Under system click on lighting ,then under subsystem click on stop lamp or turn signals . Take your DVOM an at the rear right stop lamp bulb test for B+ voltage , check ground side . See which side of the circuit has the problem . Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia

Dec 16, 2017 | Cars & Trucks

2 Answers

Left rear turn signal and brake light not working. fuse is good, bulb is good. back-up lights work.


I have a 2007 Chevy Express with the same problem. Just happened. Brake and turn signal not working on left side. Fuses good, bulbs good (dual element lamp, turn signal and break are same element) running lights work (other element) Relay blinks fast and not getting voltage at light for blinker or brake. Is there something else in the circuit I need to check. Took it to an ASE mechanic and he couldn't or didn't want to fix it. THANKS Let you know if I fix it tomorrow.

Jul 31, 2011 | 2007 Chevrolet Express Passenger

1 Answer

2003 Chevy Silverado When I apply the brakes the


I had an issue like this one on a 2007 Colorado. I assume you mean the turn signal indicator inside the truck lights up. It was a bad bulb. think it was the turn signal bulb on the side that is lighting up. As for the gear indication being dim there is more than one bulb that lights them up and one may have blown. I hope this helps.

Jul 15, 2011 | 2003 Chevrolet Silverado 1500

1 Answer

1998 chevy lumina: rear window brake light not working, left brake light not working, rear left turn signal not working


See if bulbs have burnt out in the left brake light and rear turn signal (one bulb if combined) and also rear center high mount brake light.

If the left turn signal has a slower speed than the right turn signal, this is a symptom of a bulb or bulbs burnt out.

Usually, the wiring is not a problem, but I would not rule wiring (or sockets) as a problem out.

Good luck on this repair.

Jan 19, 2011 | 1998 Chevrolet Lumina

2 Answers

99 Chevy Tahoe... Rear turn signals, brake lights, and hazards


I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!

Oct 10, 2009 | 1999 Chevrolet Tahoe

2 Answers

2001 Explorer Sport ,Rear Driver Brake Light and Turn Sig. Broke


Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have power there when brakes or turn signals are activated. Or just try another bulb.

Feb 12, 2009 | 2001 Ford Explorer Sport

2 Answers

No turn signals or side brake lights on 94 chevy suburban


the problen is probably the turn signal switch with a test light check for power at brake switch if no power check for power at turn signal switch the brake lights are incorperated through the turn signal switch

Oct 18, 2008 | 1994 Chevrolet Suburban

Not finding what you are looking for?
2007 Chevrolet Impala LS Sedan New Cars Logo

3,120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...