Question about 2001 Honda Accord

1 Answer

Intermittent speedo for 1991 Honda accord but odometer & trip ok

Odometer & trip is working. Speedometer cuts out at 20-25 mph after initial morning start. If I keep driving, check engine light comes on. If I turn car off & start driving again speedo works, then cuts out at 20-35 mph.
Speed sensor was changed (with original Honda part) a cpoule of years ago.
Hope you can helps.
Thanks,
Will.

Posted by on

  • willyq01 Dec 30, 2008

    replaced speed sensor, but problem remains. What else could it be??
    Car runs fine otherwise.


  • willyq01 Jan 09, 2009

    Had technician diagnose problem. Turns out speed sensor housing was loose.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 66 Answers

Its a faulty speed sensor or plug to speed sensor could be dirty

Posted on Dec 18, 2008

  • tom purcell Jan 08, 2009

    could be the printed cuircut board for the dash cluster seen this happen before replaced speedo chip on printed cuircut board solved problem

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why doesn't odometer work?


Could be separate cable to odometer?

Jul 13, 2012 | 1992 Honda Accord

1 Answer

1996 honda accord odometer not working the speedometer works but the odometer doesn't also the trip meter doesnt work either just all of a sudden stopped working


Hello,

Were you able to fix your problem? I'm having the same issue with my car, where the Odometer intermittently jumps from 0-48. At times when I start driving the engine stalls and the Odometer starts to act up. The Egine Light is always on. I would appreciate any help.

Aug 01, 2010 | 1996 Honda Accord

1 Answer

The odometer and trip odometer for my 1996 ford explorer stop working. However, the speed still works. Any suggestions??


The gear in the speedometer assembly is broken causing the odometer and trip odometer to be inop. You can either buy a new speedo head or buy a gear kit from an online source (google Ford speedo odometer inop)for the kit.

Nov 30, 2009 | 1996 Ford Explorer

2 Answers

My probles is the spedomometer no funtion


If your odometer is working but you have no speedo check your connection at the speed sensor first. Is your Check engine light on?
If so check for speed sensor codes. if your odometer & speedo are both out your may be having a problem in your sppedo head which will require repair or replacement.

Oct 12, 2009 | 1996 Honda Accord

1 Answer

Speedometer and Odometer not working


Try checking the fuses in the inside panel

Jun 15, 2009 | 1991 Honda Accord

2 Answers

Speedometer,odometer,trip meter stopped working!?


check your speedo cable it runs from your transmission to the back of your gauge cluster. its probleby broken or disconnected

Jun 04, 2009 | 1995 Honda Accord

1 Answer

1995 honda accord speedometer and odometer not working


Sounds like either your speedometer cable, your nylon gear on the side of the tranny where the cable ties in, or the odometer itself is shot. One of those three will set you straight. If you are able, remove the cluster, take the cable off the back, and pull it out of the sheath. You will see if its broken or not from there. If not, slide it back into the sheath, then you have to find out where the sheath meets the tranny, and pull it off of there. Then, you can get someone else to watch the speedo as you turn the cable from the bottom. If it works, great, if not, then its your cluster/odometer/speedo. If it does work, the small gear in the transmission is shot.

Feb 13, 2009 | 1995 Honda Accord

1 Answer

1991 Dodge Daytona Speedometer and Odometer not working.


I had the same problem with my 90 daytona. The tach and the speedometer would work intermitantly. I took the whole gauge cluster out, and heated all the soldering with a solder gun to reflow the connections. It seems that this is a common problem with the connections cracking. You may not be able to see the cracks in the solder.

Oct 03, 2008 | 1991 Dodge Daytona

Not finding what you are looking for?
2001 Honda Accord Logo

473 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...