Question about 2003 Toyota 4Runner

1 Answer

1996 Camry Wagon rear wiper stopped.

Front wipers work fine. Is there a fuse that controls the rear wiper separately?

Posted by on

  • 2 more comments 
  • aureal444 Dec 16, 2008

    Thank you, Ed. Yes, I would like information regarding checking circuitry. Is a relay easier to repair/replace than replacing the motor? And more cost effective?

    Thank you!


  • Toyota Ed May 11, 2010

    If you desire to see the whole wiring diagram on a .pdf file, I can send it to you. Unfortunatly, FixYa is not set up to post .pdfs. Please do not post your e-mail address here, send it to fixya_toyota_ed@yahoo.com and I will send you the PDF.

  • Toyota Ed May 11, 2010

    Remove the rear panel to expose the wiper motor. Remove the wiring connector to the motor. With the key ON, and the rear wiper switch ON, check for 12 volt DC power in these three wires:



    Solid BLUE

    BLUE with a YELLOW tracer

    BLUE with a WHITE tracer.



    Verify a good ground at the WHITE with a BLACK tracer.



    Advise of the results of this test.

  • Toyota Ed May 11, 2010

    The front & rear wipers are on the same circuit.

    The rear wiper has a relay.

    This look slike it may be an electrical diagnosis issue.

    Please respond if you want info to check circuitry.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hey i'm facing the same problem. checked for 12v, looks fine, except for the blue wire with a yellow tracer. 0v... electrical or motor issue? thanks

Posted on Feb 04, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE IS THE WIPER/WASHER FUSE LOCATED ON 2007 PONTIAC TORRENT


In the under hood fuse box , should have diagram inside the lid . Front wiper's or rear ? Front fuse # 36 - 25 amp. Plus Two relay's PCB hi and Wiper PCB relay . Wouldn't think this being fuse problem . Wiper switch , motor etc... The wiper's are control by a computer . BCM - body control module .

The windshield wiper/washer system consists of front and rear wipers. The front and rear wipers are operative when the vehicle is in accessory or run. The front wipers have 4 different modes: Mist, Intermittent, Low, and High. When the front wipers are in the intermittent mode, there are 5 delay modes to chose from, commanded by the windshield wiper washer switch through the body control module (BCM). The rear wipers has an only one mode.

If the fuse is bad , could have a short to ground or wiper motor pulling to much current (amps) . Fuse's don't just blow for no reason ! Could also have DTC'S - diagnostic trouble codes stored in the BCM .
DTC B3715
DTC B3873
DTC B3875
DTC B3922

DTC B3715 02: Front Wiper Relay Drive Circuit Short to Ground
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation.
The BCM controls the windshield wiper motor through two output controls, controlling two different PCB relays which control the desired wiper speed, high or low.
DTC B3922 00: Front Wiper Function Select Circuit

The PCB relay's are non- servicable , replace fuse box . Soldered in Your best bet mit be to take it to a qualified repair shop .

Feb 20, 2017 | Pontiac Cars & Trucks

1 Answer

Which is the fuse for windscreen washer in a 2010 yaris car ?


The fuse box is located down or just above where a driver puts their left foot, under the steering well and below the coin box. According to ABMforum.com: "The front wiper rear wiper and washers are on separate fuses (15A WSH front and rear washers 25A WIP front wiper 15A RR WIP rear wiper)."

May 15, 2015 | 2010 Toyota Yaris

1 Answer

Rear wiper notworking


Hey Joe , what make model an year vehicle ?

Apr 08, 2015 | Cars & Trucks

1 Answer

Rear wiper doesn't work


check rear wiper fuse and relay.if wiper motor getting power but do not work.rear wiper motor bad.if fuse and relay okay but no power going to rear wiper rear wiper switch could be bad.

May 14, 2013 | 2000 Seat Ibiza

1 Answer

2009 Saturn Vue. Rear Wiper and Washer both stopped working at same time.


FUSE...RELAY...CIRCUIT BREAKER...OR WIRING! WITH REAR WIPER SQUITER SWITCH ENGAGED,,,CHECK FOR VOLTAGE AT HARNESS CONNECTOR

Feb 09, 2013 | 2009 Saturn VUE

1 Answer

Front wipers stopped working on my bmw x5


Check power to the wiper .if no power might be the actual motor.

Jan 08, 2013 | 2001 BMW 5 Series

1 Answer

Could u tell me with fuses control the windshield wiper.


on the drivers side under the dash on the firewall is a fuse panel. #23 5amp is the fuse for the wiper

wiper system. if you have a taurus station wagon #19 15amp is for the rear wiper.

under the hood on the drivers side front by the battery is a power distribution panel #28

is the wiper relay. good luck!

Feb 16, 2011 | 1998 Ford Taurus

1 Answer

Location of front wiper motor relay and code stop working only rear wiper working but when you pull the wiper towards you instead of pushing away? can't find the location and have tried to find relay with...


The rear wiper is on "off" position when you pull the "stick".
The relays are under the steering wheel. if you bend yourself down to the pedals, look up, ant there is a litle door, fixed with some nuts. remove them, pull the plastic just to look inside, and you'll see the relays. the relay that control the wiper system is the bigger one. is one relay for front and back. You could open it and you'll see two electromagnets which controls some contacts. you could try clean them with a soft and clean cloth(tissue). Also check the fuses. The fuses are located on the side panel trim from the driver's door. The fuses for front and back wiper sistem are separated. On the back of the panel from the fuses you'll see a diagram with what each fuse does.Good luck.

Feb 16, 2010 | 2003 Volkswagen Golf

1 Answer

2003 Murano front wipers just stopped!!


sounds like thats it, you can check it for power,to make sure but it does sound like the motor.

Dec 13, 2009 | 2003 Nissan Murano

2 Answers

Rear wiper does not work at all. front wipers work fine. rear washer works


1. check the fuse to the rear wiper motor
2. check for power to rear wiper motor at the motor (power wire going in to the wiper motor with rear wiper switch on)
If you have good fuses & have power going in to the rear wiper motor...
3. Pull old rear wiper motor and install a new rear wiper motor.
Thank you please drive thru......

Feb 26, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
2003 Toyota 4Runner Logo

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

71162 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6992 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...