Question about Cadillac DTS
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
Posted on Aug 14, 2009
ok, In this New of a vehicle there are no screws holding the headlight in if you just need to replace a headlight because it is burned out. Look at the back of the light where the wires attach and you should see the wires going into what appears to be a coupling. Get a hold of that and turn. After it unlocks you can remove and replace the bulb. If you are replacing the Headlight assembly because it was damaged there are typically 2 long scews on the top front that appear to be adjsutment screws and 2 smaller ones in each side, again on top. Good Luck
Posted on Aug 27, 2009
you should have to go thru under the hood to the backside of the lamp assembly. There should be either a hard plastic cap or a plastic dust cover that has the wires going thru it to the lights. If it is the hard cover (looks like a jar cap) turn it 1/4 turn counterclockwise and pull it out of the way. Take the bulb/socket out. Unclip the old one- Put the new one in. (DO NOT TOUCH THE GALSS PART OF NEW BULB). Then re-assemble
Posted on Mar 11, 2010
It holds 7.5 quarts. If you need a copy of your owners manual give me an e-mail address to send it to.
Don't forget to rate this answer.
Posted on Apr 17, 2010
Tips for a great answer:
Feb 24, 2016 | Cadillac Cars & Trucks
Jun 13, 2015 | 2008 Cadillac Dts
Jul 29, 2011 | 2006 Cadillac DTS
Mar 16, 2011 | 2006 Cadillac DTS
Mar 01, 2011 | 2006 Cadillac DTS
Jan 15, 2010 | 2006 Cadillac DTS
Jan 03, 2010 | 2006 Cadillac DTS
Dec 09, 2016 | 1992 Cadillac Seville
220 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: