Brake light bulb was changed, now brake light is on
Brakelight bulb changed, when headlighs are on the brakelight is lit up bright also the rear stoplight on the boot. I've also notice that the airbag light on the dash is staying on.
When headlights is switched off and i press the brake pedal there is a chime and the dshboard light comes on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
lamp failure light on possible because the SECOND filament in your STOP/TAIL Light Bulb is burned out- change one side and check fail lamp again- repeat on other side- fail lamp works off of resistance-burned or blown bulb is only way it lights unless you have a wiring issue
hi the rear high level brake warning light in rear screen ? works with the other two brake lights at same time when you press brake pedal with ignition on ? so may i suggest you check the other brake lights are working ? if not ? check these bulbs? reason being that from the symptoms you describe that high level light is staying on ? it would suggest that the brake light switch at the pedal is not operating ie not putting brake lights off when pedal is off and would suspect the brake lights have been on for some time and burned bulbs out due to the brakelight element in bulbs are high wattage if you check on what i have suggested? and is the case ? come back and will advise you how to adjust brake switch easy diy hope this helps? best wishes from the uk
Your rear brake bulb wiring is connected to the high stop light, but when your problem occurs, it usually means there is a short in one of the brake bulbs (or associated connectors).
Firstly, inspect the brakelight fuse (just in case the rear lights are on a separate circuit).
Secondly, check for blown brakelight bulbs (and replace if necessary).
Thirdly, remove the bulbs and ensure they are the correct type (i.e. the bulb contacts must match the bulb holder - usually double contacts). If you have the incorrect contacts type, this will cause a short also.
1 - are you SURE theyre the right bulbs! - if theyre too bright they can blow the fuse, if theyre the wrong type of bulb they will blow the fuse..
best get the bulbs direct from ford, they are always in stock, so are the proper fuses.
2 - theres a center brakelight isnt there? check this bulb too for proper wattage and size/shape
Other than that maybe the wiring in the boot is damaged and shorting??
Leave feedback good or bad.
Problem could be the Brake Light Control Module. That's about the only other thing other than a bad wire somewhere if the bulbs and fuses are good. 91 Accord has 2. One on each side in the smaller of the 2 rear tail light lenses. In order to change the module you have to remove the smaller of the rear tail lights. Drivers side is 5 pin. Passenger side is 6 pin.