Question about 2001 Jeep Cherokee

Open Question

2001 Cherokee central locking and rear wiper not working

Car worked fine going to work, and when leaving work I found the central locking was not working though key fob still de-activates the alarm and lets the indicators blink, and the rear wipers don't work either.
I have checked the fuses and they are all OK..

Please help.

Many thanks.


Mike Wright

Posted by on

5 Suggested Answers

emissionwiz
  • 63842 Answers

SOURCE: key fob will not undo

If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.

If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:

1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.

5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.

6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.

7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.

Posted on Oct 16, 2008

tepfy
  • 319 Answers

SOURCE: 1996 jeep grad cherokee wiper fuse

either on the passanger side or under the hood behind the battery. open them up and read them. They will say which ones they go to.

Posted on Dec 20, 2008

  • 412 Answers

SOURCE: 2005 Chrysler Grand Voyager. Central locking

the body control module may need a software update..check with your local dealer

Posted on Jun 12, 2009

  • 54 Answers

SOURCE: remove front wiper arms. Lift arm, slide out

Just pry them off. Make sure the tab is out the whole way. Sometimes they can be tough to get off. Spray with wd40 it should aid in getting it loose. You could even tap it a few times with a rubber mallet or a light hammer, just be careful. Good luck if this helps let me know.

Posted on Jun 19, 2009

raygin
  • 322 Answers

SOURCE: Jag S-Type -intermitent fault where the remote fob does not work

This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.

Posted on Jul 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central locking system


Sounds like this car was under water...????

Not knowing the year is a down point.!

I would remove and check all fuse block relays and switches. Both under the hood in engine area and under the dash.
If it was me, I would bring it to a auto electrical shop and have them check to system.

May 03, 2014 | Daihatsu Cars & Trucks

1 Answer

I can't get my windshield wipers to come on and have already changed the fuse with no results. they worked fine yesterday but have having trouble with the relays under the rear seat. is there a re


The wipers are controlled by a central computer called the BCM, you must have that tested to see what fault codes are in memory of the module, this is the first step.

Feb 13, 2013 | 2001 Oldsmobile Aurora

1 Answer

2001 330i BMW hazard lights & central locking in car won't work


I'm having the same problem have you fixed yours?

Jul 11, 2010 | 2001 BMW 330

1 Answer

The Rear Wipers on my 2001 1500 Chevy Suburban Stopped working


Unplug the connector at the rear wiper motor, turn the switch on and probe the wires with a test lamp, if you have power back there you more than likely have a bad motor. If there is no power start checking fuses they are all labeled easily on the back side of the fuseblock covers both on the dash and underhood. Good Luck!!!

Mar 15, 2009 | 2001 Chevrolet Suburban

2 Answers

Rear wiper does not work at all. front wipers work fine. rear washer works


1. check the fuse to the rear wiper motor
2. check for power to rear wiper motor at the motor (power wire going in to the wiper motor with rear wiper switch on)
If you have good fuses & have power going in to the rear wiper motor...
3. Pull old rear wiper motor and install a new rear wiper motor.
Thank you please drive thru......

Feb 26, 2009 | 2001 Ford Expedition

1 Answer

Rear window wiper not working


follow the wires ,there is a short

Jan 03, 2009 | 2005 Jeep Grand Cherokee

1 Answer

2000 Jeep Cherokee Sport, window washing does not work


the little pump inside the washer fluid reservoir is bad, replace it

Dec 27, 2008 | 2000 Jeep Grand Cherokee

1 Answer

Front widshield washer fromm 1999 Cherokee doesn't work


Your rear bottle for the wipers should be at the back of the vehicle.Look in back for removable panel and bottle should be there.Turn your ignition on(no start)and activate rear washer Listen for the sound of the motor

Nov 20, 2008 | 2000 Jeep Cherokee

Not finding what you are looking for?
2001 Jeep Cherokee Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...