Question about 2003 Chevrolet Silverado 1500

1 Answer

Original equipment replacement

Having trouble locating a replacement center console assembly for my 2003 Chevy Silverado 1500 2WD. My lid snapped and can't be fixed. I need a charcoal grey replacement that bolts in to the existing bracket. Any suggestions?

Posted by on

  • tmcbroom Dec 19, 2008

    Same problem with my 2004. Tryed repairing and only made it worse.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Dealership

Posted on Dec 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to remove rear cup holder


  1. If equipped with an automatic transmission, remove the shift lever knob by pulling the knob straight up. Then carefully Carefully pry up and pull to remove the transmission shift indicator bezel.
  2. If equipped with a manual transmission, remove the shift lever knob by loosening the locknut and then unthreading the knob from the shaft. Pull up the shift boot to remove.
  3. Pry up and pull to remove the transfer case selector bezel.
  4. If equipped, loosen the console trim panel retaining screws, then carefully pull up on the console trim panel and remove from the vehicle.
  5. Open up the storage box lid on the console and remove the 2 retaining screws located at the bottom of the compartment.
  6. Remove any other console housing retaining screws.
  7. If necessary, disengage the wiring harness connector.
  8. Carefully pull up on the console assembly and remove from the vehicle
  9. If necessary after removing the console unit, remove the A/C-warm air duct from the center of the floor
  10. Installation is the reverse of removal.

Oct 31, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Where is the amplifier in a 2003 chevy silverado 1500


Hello and welcome. the radio amp is mounted under the center console. the console will have to be removed to gain access to the amp. here is a picture of the amp


3da9a45.gif

Aug 30, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

Location and removal of the air vent actuator. step by step on how to get to it and replace it. Air blows and I can control hot and cold but I cant change from floor to vent to dash. It just keeps blowing...


Removal & Installation
  1. Remove the floor air outlet duct extension from the floor duct.
  2. Remove the center console, if equipped.
  3. Remove the screws from the center console duct, if equipped.
  4. Remove the center console duct, if equipped.
  5. Disconnect the electrical connection at the mode actuator.
  6. Remove the mode actuator mounting screws from the HVAC module.
  7. Remove the mode actuator as an assembly with the actuator cam.

98d9332.gif
Mode actuator location

To install:
  1. Install the mode actuator as an assembly with the actuator cam.
  2. Line up the heater/defroster valve lever with the mode actuator cam slot.
  3. Line up the A/C valve lever with the mode actuator cam.
  4. Install the mode actuator mounting screw to the HVAC module and tighten to 14 inch lbs. (1.6 Nm).
  5. Connect the electrical connection at the mode actuator.
  6. Install the center console duct, if equipped.
  7. Install the screws to the center console duct, if equipped, and tighten to 14 inch lbs. (1.6 Nm).
  8. Install the center console, if equipped.
  9. Install the floor air outlet duct extension to the floor air duct.
  10. Calibrate the HVAC module actuators.

Apr 18, 2010 | 2004 Chevrolet Tahoe

1 Answer

2003 chevy silverado 1500HD loss of all gauges and after awhile they come back on


There is a known issue with the dash gauges on the 2003 Silverado. Check with your dealer, because there is a service bulletin that allows them to replace the dash assembly as a factory warranty replacement even if you are out of warranty (if you are the original owner).

Dec 27, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

Trying to locate cabin air filter in 2003


The 2002/2003 Silverado was a change over year for Cabin Air filters. I know with the Chevy Avalanche the 03's did not have them and 02's did. The dash/center console changed with the 03's, and I believe it was done away with in that change over.... Still shows up on catalog, but the 03 has no Cabin Filter.

Good luck, and Merry Christmas

Dec 06, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

Hello on a 2003 chevy silverado pick up truck 4x4


A bad ground or wire somewhere is pulling current from your battery when it's not running. Use a test light, try to find a circuit that is hot when it shouldn't be. It will take some time and patience.

Oct 25, 2009 | 2003 Chevrolet Silverado 1500

1 Answer

I am trying to remove the center console of a 2003 chevy impala to install an after market radio. Can someone give me directions please?


There are 2 10mm bolts in the compartment hold of the center console that must be removed. Two similar 10 mm bolts must be removed at the front of the center console, near the driver's and passenger's lower legs. The top of the center console, where the shifter is located, snaps out. With this top piece removed, the cigarette and auxilary outlet can be disconnected. Four more bolts near the shifter bracket need to be removed, and then the console is free. Hope this helps someone. I needed to remove the center console to install a component for a car stereo.

Brian

Jul 06, 2009 | 2003 Chevrolet Impala

1 Answer

Chevy silverado 1500 4 wheeldrive 2003


Raise the truck. Remove the wheel, brake caliper, caliper mounting and the dust cover in the center of the hub. Remove the ABS wiring, remove the large nut from the center of the hub. On the back side of the hub are 3 bolts, remove those and the hub should come off. Good Luck

May 07, 2009 | 2003 Chevrolet Silverado 1500

2 Answers

Bad sensor on chevy truck


There are 2 both located in the block..

Aug 11, 2008 | 2002 Chevrolet Silverado 1500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...