- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
To remove the water pump of Fiat Punto/Stilo:
1 Disconnect the battery negative terminal.
2 Drain the cooling system.
3 Remove the timing belt.
4 Unscrew the retaining nut and the three bolts and withdraw the coolant pump (see illustration). If the pump is stuck, tap it gently? using a soft-faced mallet - do not lever between the pump and cylinder block mating faces of Fiat Punto (Stilo).
When was the transmission last serviced it may be the oil is low or old causeing it not to select gear straight away or it could be the bands inside the box may be worn i would try the service first before jumping into worn bands
hope this helps good luck
The clutch in the Fiat stilo abarth selespeed uses the same fluid as the braking system. Just find the container in the engine bay with the braking fluid. And top up with ''DOT 4 Brake & Clutch Fluid'' Note it's not the oild for the Gearbox or selespeed. You should never touch the container that holds the fluid for the Selespeed.
Hi, I've got the same problem. They run on brake fluid not cable. I started to bleed the Clutch to adjust the bite point but after one bleed the pedal went to the floor and can't get it back. Tried pressure bleeding it but seems to be no fluid coming out of the bleed nipple. No leaks. Can any one help??
Check that you have oil in the gearbox and that the drive shfts are securely fitted in the box. If all this is ok, then a reconditiond, second hand or new replacement box is the order of the day. Before you buy another box, when the box is off the engine, dismantle the clutch and inspect it. It may be the preasure plate is breaking up. Anyway it is only another ten minutes on the job. If you find wear in the clutch, repace it at the same time as you change the box. Sorry for the bad news.