Question about 1993 Chrysler Concorde

1 Answer

Transmission whan i start my car it starts makeing a funny crying noise and it wont move when i put it into gear my name is darrin can you tell me whats going on

Posted by on

  • Anonymous Dec 17, 2008

    I own a 93 Concorde Myself. It has 147,000 miles on it. I bought it in 2004

    with 116,000 miles on it. I started to notice a whining or a slight grinding in

    the Passenger side front end after about 2 months of daily driving. Then the car got really crazy on me. The starter would start clicking and would start

    after about 30 Clicks, The Battery drained out and I replaced it, My fuel gauge stopped working(Still cant find problem-Not the ground).Recently, My ABS light came on and the popping noise got really loud on the passenger side front. 2 Mornings ago, I started it up, Put it in reverse and BANG! The Entire CV(Bearing and all)come flying off the car and now Im stuck with no car.New parts will cost me upwards of $ 600.00 plus labor.

    Let me tell you that these are 15 Year old Chryslers, They are good cars

    for the most part and are pretty reliable, However, To spare your wallet or

    purse, Your better off buying Parts at a Salvage Yard and putting them on yourself(If you can)You can buy a Haynes Concorde Manual at any Parts

    store for about $14. I have driven this car on LD trips through 3 or 4 states

    with no problems. It seems that the Issues are intermittent. The problems are just the cars way of telling you that the scheduled services that were

    supposed to have been done were not and now its payback to the driver

    whether you are the original owner or bought someones lemon. Preventive

    Maintenance is crucial to the life and performance of the Car in and out

    of Warranty. David Y Minnesota

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 146 Answers

The whining noise you hear is the pump in your transmission sludge builds in the trans pan it stops the filter up pull the pan off your trans you will see the sludge you probably need a new transmission.

Posted on Jan 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I shift gears it makes a funny noise and wont move


Sounds like a new transmission is needed, I assume this is an automatic.

May 11, 2016 | Cars & Trucks

3 Answers

When i start my car and go to put it in gear it wont move.


When you say rocky spot, what do you mean? If you mean there were rocks in the roadway, you could have put a small hole in the transmission pan which leaked all the fluid out of it. First thing I would do is check the fluid level on the transmission dipstick and look for leaks on the ground under the car.

May 01, 2015 | 2002 Ford Taurus

1 Answer

2004 jeep liberty won't move when put in gear (like brakes are locked).crank it in neutral put in gear it will go till i touch brakes then won't move again.WHAT'S WRONG WITH THIS THING.


gear, is this a Manual trans? or AUTO you said gear.
what gear, please name the gear, 1,2,3,4,5 R
or PRNDL ( a/t box auto matic) what shift lever selection?
what is out door air temp, you do know brakes can get wet and freeze right?
it wont go you meant? until brakes are touched, key word won't?

ok engine only starts in PRNDL set to N??
is that it?
and then when you shift to D, the car will not move
what about the other gears.? try them all yet?

my guess (wild) is that you dont know how park lock out works.?
that you must hold the brake pedal down to shift to park or neutral.
is that it? (read operators guide?)

my guess is car is not drive-able. key point1 (a dead car)
point 2, engine starts and runs. and races on demand with gas foot.
point 3, im lost. (no trans stated or clear symptoms.)

my jeep has 6speed manual box
and the clutch allows me to start car.
on Automatics trans must be in park or neutral to crank engine.

"it will go till i touch brakes"



I read that 10 times,
my 2nd guess. the engine stalls ?

IS THAT IT, stalls means engine RPM is 0
and right foot actions are dead.
and all dash lamps glow, telling you STALL is now.

Feb 26, 2015 | 2004 Jeep Liberty

1 Answer

I have a 2010 nissan maxima .that starts bit won't shift in gear, makes a humming noise too


Hi! I am going to assume the engine runs ok and the shifter moves ok. If its a automatic transmission and it makes noise but wont move in gear the transmission fluid level may be low.Check that first

Jan 21, 2015 | Nissan Cars & Trucks

1 Answer

Four wheel drive not working on a 1990 chev 1500 pickup with manual tranmission?


Yep! it does sound as if you've lost the proper connection between your engine flywheel and the transmission clutch-plate. That baby is crying for your TLC after being such a faithful trooper all these years.

Jan 08, 2014 | Cars & Trucks

1 Answer

I have a 1989 z24 cavilier and i just changed the slave cylinder and now when i start it and press the clutch it makes a grinding noise. When i try to put in gear it wont go in any gears and makes some...


hi i was wondering if anyone can tell me whats going on with my 89 z24 cav i just replaced two shifter cables on she's a 2.8l 5 speed and now when i starts her and lets the clutch out she dosen't engage at all but she has no noises and no grinding goes in gear fine but just won't move hope someone can help thanks

Jul 04, 2012 | Cars & Trucks

1 Answer

I have a 92 Honda Accord and the transmission slips out of gear when it downshifts from 4th to 3rd. I step on the gas and the rpm's go up but the car does not move, like it is in neutral. I turn the car...


Sounds like transmission is screwed. Worn sun gears due to lack of proper care in the transmissions earlier days. Must have run dry & lost teeth on gears. New car time.... Cheaper for a used transmission to be put in then have the current one fixed.

Mar 22, 2017 | 1992 Honda Accord

Not finding what you are looking for?
1993 Chrysler Concorde Logo

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...